Reviewing Memory Numbers; Dialing A Memory Number; Chain-Dialing Service Numbers; Testing Stored Emergency Numbers - Radio Shack 900 MHz Digital Spread Spectrum Cordless Phone with Dual Caller ID Owner's Manual

Reviewing Memory Numbers

Handset
To review your memory numbers stored in
the handset, press
MEM
&' &' &' &' (& (& (& (&
location numbers ( –
stored with each number (or
you did not store a name) appears. To view a
memory location, press its number (
repeatedly press
VOL/CID
To see the stored phone numbers, press
7 7 7 7
. An arrow to the right of the num-
FLASH
ber means it is longer than 14 digits. Press
7 7 7 7
again to see the rest of the num-
FLASH
ber.
6 6 6 6
Repeatedly press
REDIAL
name display.
To exit the memory number list, press
To see a stored name and phone number at
the same time, press
SELECT/INTCM
the cursor is by a memory location number.
To exit this display, hold down
until the display clears.
Base
To review your memory numbers stored in
the base, press
MEMORY
pears. Press a memory location number
to review the number you have stored.

Dialing a Memory Number

To dial a number stored in handset's memo-
ry, lift the handset and press
memory location numbers appears. Choose
a memory location ( –
01
number or by repeatedly pressing
8 8 8 8 9 9 9 9
or , then press
TALK
You can also dial a memory number after
pressing . Press
TALK MEM
not change but the phone is in memory recall
mode) then enter a memory location number.
20
. The list of memory
) and the name
ý 2C[cehodd4 ý 2C[cehodd4 ý 2C[cehodd4 ý 2C[cehodd4
if
– ) or
01 20
8 8 8 8 9 9 9 9
or .
to return to the
.
MEM
when
DELETE/CH
I[b[Yj I[b[Yj I[b[Yj I[b[Yj BeYWj_ed BeYWj_ed BeYWj_ed BeYWj_ed
. ap-
–
0 9
. The list of
MEM
) by pressing a
20
VOL/CID
.
(the display does
Operation
To dial a number stored in the base's memo-
I[b[Yj I[b[Yj BeYWj_ed
I[b[Yj I[b[Yj
ry, press .
MEMORY
Press a number key ( –
0 9
the number contained in the selected memo-
ry location. Press
SPEAKER
ber on the display.
Note: If you select an empty memory loca-
tion, no number appears.

Chain-Dialing Service Numbers

For quick recall of numbers for special ser-
vices (such as bank by phone), store each
group of numbers in its own memory loca-
tion. Dial the service's main number first.
Then, at the appropriate place in the call,
press (or on the base) and en-
MEM MEMORY
ter the number for the location where the ad-
ditional information is stored.
Testing Stored
Emergency Numbers
If you store an emergency service's number
(police department, fire department, ambu-
lance) and you choose to test the stored
number, make the test call during the late
evening or early morning hours to avoid peak
demand periods. Also, remain on the line to
explain the reason for your call.
BeYWj_ed
BeYWj_ed BeYWj_ed
appears.
); the display shows
to dial the num-