Table of Contents
Advertisement
Turning the power on/off
1
In the power-off state, press and hold the
power
button of this unit for approx.
3 seconds until the LED (blue) blinks
• A beep will sound, and the LED (blue) on the remote
controller will blink slowly.
To turn the power off
• Press and hold
for approximately 3 seconds.
A beep will sound and the power will be turned off.
■
Note
• When the unit is not operated for approximately 5 minutes, the power will
automatically turn off. (See "Auto power off" (→ P. 7))
How to wear the earphones
Hung this unit around the neck with the remote controller on the right side, and put
on the earphones.
Move the cord adjuster toward the back of the head, and adjust the cord length.
Clip
■
Note
• When using the earphones for the first time, slide the clip to achieve a
comfortable fit, and adjust the clip to the position where sounds are most easily
heard.
• Depending on the wearing condition, sound quality may change.
■
Attension
• Do not forcibly deform the clip.
The clip may be damaged.
Connecting a Bluetooth
Preparation
LED
• Place the Bluetooth
• Check the device operation using its operation instructions as required.
Pairing (Registration) this unit with the Bluetooth
connection
1
In the power-off state, press and hold the power button of this
unit until the LED blinks
Power
• The unit starts to search for the Bluetooth
2
Turn on the power of the Bluetooth
Bluetooth
3
Select "RP-BTS10" from the
Bluetooth
• The MAC address "□□□□□□" ("□"
• If prompted for a passkey, input the
4
Check the connection with the
Bluetooth
• The LED will blink in blue and red
Cord adjuster
■
Note
• If connection to a device is not established within approximately 5 minutes, the
unit will be turned off. Perform pairing again.
• You can pair up to 8 Bluetooth
the device with the oldest connection will be replaced. To use it, perform pairing
again.
device within approx. 1 m from the unit.
®
When pairing a device for the first time
When pairing a second or subsequent devices : approx. 5 seconds
LED will blink in blue and red alternately.
function
®
device's menu
®
stands for a character that is unique
to each set.) may be displayed
before "RP-BTS10" is displayed.
passkey "0000 (four zeros)" of this
unit.
device on the unit
®
alternately until the connection with
the device is completed. When an
electronic sound beeps and the LED
(blue) blinks twice every approx.
2 seconds, pairing (registration) is
completed. (Connection established)
devices with this unit. If a 9th device is paired,
®
device
®
device for
®
: approx. 3 seconds
device for connection, and the
®
unit, and enable the
®
(Ex.)
Bluetooth
Bluetooth
ON
Device
Select
RP-BTS10
5
Hide quick links:
Advertisement
Table of Contents
