Table of Contents
Advertisement
WARNING
Do not open the equipment
unless totally familiar with
electrical circuits and
service manual.
ELECTRICAL
SHOCK
HAZARD
Wear a safety belt and hard
hat when working on the
scanner unit.
Serious injury or death can
result if someone falls from
the radar scanner mast.
Construct a suitable service platform
from which to install the scanner unit.
Serious injury or death can result if some-
one falls from the radar scanner mast.
Turn off the power at the mains switch-
board before beginning the installation.
Fire, electrical shock or serious injury can
result if the power is left on or is applied
while the equipment is being installed.
Do not install the display unit where it
may get wet from rain or water splash.
Water in the display unit can result in fire,
electrical shock or equipment damage.
HIGH TENSION WARNING
Only qualified personnel
should work inside the
equipment.
WARNING
Be sure that the power supply is
compatible with the voltage rating of
the equipment.
Connection of an incorrect power supply
can cause fire or equipment damage. The
voltage rating of the equipment appears
on the label above the power connector.
Use only the specified power cable.
Fire or equipment damage can result if a
different cable is used.
CAUTION
Ground the equipment to
prevent electrical shock and
mutual interference.
Observe the following compass safe
distances to prevent deviation of a
magnetic compass:
Display
unit
Scanner
unit
Name: Danger Label
Type: 14-055-4202-0
Code No.: 100-245-220
ii
Standard
Steering
compass
compas
0.50 m
0.40 m
1.00 m
0.80 m
DANGER
Electrical shock hazard.
Do not touch parts in -
side this cover.
Advertisement
Table of Contents
