External Device Tab - Hall Research Technologies CNT-IP-264 User Manual

CNT-IP-264
External Device Tab
All the 3rd party devices that are used along with the Model CNT‐IP‐264 and
HHD‐264/FHD‐264 subsystems are referred as external devices.
The CNT‐IP‐264 can control external devices via serial, Telnet and/or TCP.
NOTE
The External Device tab has two sub tabs to manage the IP configuration
and actions that relate to the external devices on the network.
Device Tab
Used to add/remove, change the IP configuration of external devices.
To add IP device:
Click Add Device  Enter Name  IP Address
of the external device  TCP PortClick OK
NOTE
If your device has a Telnet interface and supports raw TCP
connection, enter the telnet port in Port text field.
To add a Serial device: Add the FHD/HHD
connected to the corresponding RS232 port as a
device.
Click Add Device  check SOIP  Select
FHD/HHD from the Name  IP and Port fields
will be filled automatically Click OK
NOTE Port: 7000 -- SOIP port of FHD/HHD 264
To send serial commands to an external device, connect your device
to the FHD/HHD264 RS232 port.
Deleting a device will remove all the actions linked to it
Figure 2.5 Adding IP Device
Figure 2.6 Adding Serial device
CNT‐IP‐264 User's Manual 10