PS-BH-10 110-120V~, 60Hz, 12A For illustrative purposes only. Do not forget to try these other fine Intex products: pools, pool accessories, in-home toys, airbeds and boats available at fine retailers or visit our website. Due to a policy of continuous product improvement, Intex reserves the right to change specifications and appearance, which may result in updates to the instruction manual, without notice.
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016 English TABLE OF CONTENTS Warning..................3-4 Parts....................Product specifications..............Set-up..................... 8-12 Operation..................13-14 LED Code Chart................15 Maintenance and Chemicals............16-22 Storage................... 22 Troubleshooting................23 Warranty..................24 Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016 English IMPORTANT SAFETY INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be followed, including the following. READ AND FOLLOW ALL INSTRUCTIONS DANGER • Risk of Accidental Drowning. Extreme caution must be exercised to prevent unauthorized access by children.
• Do not allow the water in the spa to freeze. Do not turn on the spa when the water is frozen. • Do not use the spa if damaged in delivery and/or malfunctioning in any fashion. Contact the Intex service center for further direction.
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016 English PARTS Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts. NOTE: Drawings for illustration purpose only. Actual product may vary. Not to scale. S AVE THESE INSTRUCTIONS Page 5...
Page 6
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016 English PARTS (continued) Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts. REF. NO. DESCRIPTION QTY. PART NO. CONTROL BASE 12125 CONTROL BASE BACK COVER...
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016 English SET UP Site preparation and requirements • For outdoor installation only. For household use only. • The spa must be setup on a level, flat and smooth surface that is capable of supporting the maximum load of the filled spa with four adult occupants;...
Lay out all the parts on the ground and make sure all the parts are accounted for. For missing or damaged parts contact the appropriate Intex Service Center listed in the separate “Authorized service Centers” sheet. Safety Sign Card Posting The Safety Sign card included with the manual shall be posted in an area visible to the users of the spa to alert them of the safety rules and warnings.
Page 10
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016 English SET UP (continued) Insert the horizontal beam through the bench sleeves and the spa lateral upper strap sleeves. Then insert the protruding connectors over the L shape U legs vertical pipes (see drawing 5). Press Inflation Inflate the Spa Tub Wall...
Page 11
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016 English SET UP (continued) Replace the air valve cap back. NOTE: The cap is designed to be screwed on and off. Never exert force as this could cause the complete internal inflation system of the valve to come loose.
Page 12
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016 English SET UP (continued) Spa Control Unit Installation Connect the spa control unit to the spa tub (see drawing 15). Hand-tighten the connectors securely. Do not use tools to tighten. Reinstall the back cover (2) to the spa control base (see drawing 16).
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016 English OPERATION SPA CONTROL UNIT PANEL 1: On/Off Button 2: Heat Button 3: Celsius/Fahrenheit Toggle Button 4: Temperature Increase Button 5: Temperature Decrease Button 6: Water Filter Button 7: Bubble Button 8: LED Display 9: Filtration section indicator light ("A"...
Page 14
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016 English OPERATION (continued) Temperature Adjustment Buttons: Pressing the Temperature Increase or Decrease buttons will cause the LED to flash. When flashing you can adjust to the desired temperature setting.
Reassemble the control unit back to the tub. Plug the GFCI/RCD and restart all over again. • If problem persists, contact Intex Service Center. Water temperature sensor broken • Contact Intex Service Center. After 72 hours of continuous heating operation, the pump will • Press the button to re-active the hibernate automatically.
Do not add chemicals if the spa is occupied. This can cause skin or eye irritation. Concentrated chlorine solutions can damage the spa tub. In no event is Intex Recreation Corp., Intex Development Co. Ltd., their related companies, authorized agents and service centers, retailers or employees liable to the buyer or any other party for costs associated with the loss of spa water, chemicals or water damage.
Page 17
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016 English SPA WATER CHEMISTRY AND BALANCE Preferred Water Chemistry Reading Minimum Ideal Maximum Free Chlorine 2 ppm 2 - 4 ppm 5 ppm 7.2 - 7.6 Total Alkalinity (TA) 60 ppm 80 ppm 120 ppm...
Page 18
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016 English SPA WATER CHEMISTRY AND BALANCE (continued) SPA Water Adjustment How to adjust the spa water chemistry when the levels are off the range. CAUTION: Always follow the chemical manufacturer’s directions, and the health and hazard warnings.
Page 19
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016 English SPA WATER CHEMISTRY AND BALANCE (continued) Lowering pH Lowering pH Using Muriatic Acid Volume 210 gal (795 L) 310 gal (1173 L) Total Alkalinity 120 ppm 80 ppm 120 ppm 80 ppm 0.028 qt...
Page 20
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016 English MAINTENANCE Spa Tub Drainage Turn off the spa control unit. Deflate the benches, and remove the benches and L shape U legs from the tub side wall. Connect the drain valve adaptor (11) to a garden hose and point the other end of the garden hose to a suitable draining area (see drawing 19).
Page 21
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016 English MAINTENANCE (continued) Spa Tub Cleaning If dirt is visible in the water or water becomes cloudy and proper water chemistry does not clear it up, change the water and clean the spa tub. See “Spa Tub Drainage” section on how to drain the spa. While empty, remove the cartridge housing from inside of the spa tub wall, clean and/or replace the filter cartridge.
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016 English MAINTENANCE (continued) Spa Tub, Benches and Cover Air Bladder Repair Use the enclosed repair patch to repair any puncture: • Clean and dry the area to be repaired thoroughly. •...
BUBBLE AIR BLOWER • Air blower pump is too hot. DOES NOT WORK restart all over again. • If problem persists contact Intex Service Center. FILTRATION PUMP • Dirty filter cartridge. • Clean or replace the filter cartridge in time.
WARRANTY Your PureSpa has been manufactured using the highest quality materials and workmanship. All Intex products have been inspected and found free of defects prior to leaving the factory. This Limited Warranty applies only to the PureSpa listed below. The provisions of this Limited Warranty apply only to the original purchaser and is not transferable.
Need help?
Do you have a question about the PureSpa PS-BH-10 and is the answer not in the manual?
Questions and answers