Rs232 Communication Commands - TechLogix Network TL-RKPS-01 User Manual

The interface of the control software is showed as below:
Parameter Configuration area
Please set the parameters of COM number, bound rate, data bit, stop bit and the parity
bit correctly, and then you are able to send command in Command Sending Area.

4.2.3 RS232 Communication Commands

Communication protocol: RS232 Communication Protocol
Baud rate: 9600
Command
All@!
All$!
Monitoring area, indicates if
the command sent works.
Data bit: 8
Function
Switch on all output channels.
Switch off all output channels.
TL-RKPS-01 User Manual
Command Sending area
Stop bit: 1
6
Parity bit: none
Feedback Example
All Open.
All Closed.
www.tlnetworx.com