Page 2
Understanding how your monitor works helps you obtain the highest performance levels. Before setting up and using your Constant Care 1500 Secure Sound Monitor, please read this Owner’s Manual completely. It provides helpful tips to ensure the best operating circumstances for assisting you in monitoring your child.
Page 3
WARNING • DO NOT OPEN. NO USER SERVICEABLE PARTS INSIDE. RISK OF ELECTRIC SHOCK. MAY CAUSE INJURY, FIRE, OR DEATH. • DO NOT use near water. • DO NOT place furniture on cord. • NEVER place the baby’s unit or its adapter in the crib or playpen, or within the child’s reach.
IMPORTANT SAFETY INSTRUCTIONS The Evenflo Constant Care 1500 Secure Sound Monitor should not be used as a replacement for adult supervision of children. Please note that any modification of the transmitter or receiver will violate FCC compliance and can void the user’s authority to operate this monitor set.
Page 5
• It has been dropped or something inside is damaged. • If any parts are missing or broken. Call Evenflo’s Parent Link at 1-800-233-5921 for instructional literature or product information if needed. Refer to the Troubleshooting Chart in this Owner’s Manual before returning your monitor for servicing.
Using Your Monitor Antenna AC Adapter On/Off Switch Microphone Channel Switch Adapter Jack Power Light The Baby’s Unit The Baby’s Unit is a transmitter, which sends sounds to the Parent’s Unit (receiver). It is powered either by a 9 volt battery or by an AC adapter which is included.
Page 9
Before you set up your monitor, please read all instructions and warnings carefully and completely. Antenna AC Adapter Earphone Channel Speaker Jack Switch Green Power Light On/Off Volume Dial Adapter Jack Sound Lights The Parent’s Unit The Parent’s Unit receives sound from the Baby’s Unit (transmitter) and is powered either by three AAA batteries or by an AC adapter which is included.
Troubleshooting Guide POSSIBLE CAUSE PROBLEM Power indicator • Unit isn’t getting power. light isn’t working. • Battery may be weak. Audio Out-of-Range • Parent’s Unit may be outside the transmission alarm sounds. range of the Baby’s Unit. • Baby’s Unit and Parent’s unit are on different channels.
Page 11
SOLUTION • Make sure unit is properly plugged into the wall and the outlet is switched on. • Replace battery. • Move Parent’s Unit closer to the Baby’s Unit. • Make sure that both units are set to the same channel. •...
Product, Evenflo warrants this Product (including any accessories) against defects in material or workmanship. At Evenflo’s option, Evenflo may repair or replace any Product that is determined to be defective by Evenflo and determined to be covered by this warranty.