Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Cengar JP901
Summary of Contents for Cengar JP901
-
Page 2: Ec Declaration Of Conformity
Based on the following Harmonised Standards: EN13463-1:2009 And therefore complies with the essential requirements of those directives. Additional Information: ATEX Coding II 2G T5 Certificate No. TRAC09ATEX21236X Technical File No. CEEX-0803 Authorised Signature: Date: 15/12/09 Title of Signatory: General Manager - Cengar Ltd. -
Page 3: Specifications
Cengar Air Saw Model JP 901 We recommend normal safe working practices should be followed as per the Health and Safety at Work Act, or the appropriate National and State Laws. We recommend that eye protection be worn when using Cengar Saws... - Page 4 Think safe Act safe Be safe LUBRICATION Use Cengar Green Oil with longer lasting coating properties for best results. Cengar Green Oil is specially prepared to: - Emulsify the water generally found in compressed air lines. Give perfect mist lubrication.
-
Page 5: Operating The Saw
Very little maintenance is required if the correct oil is used, but incorrect oil will soon break down into sludge, slowing down the action of the saw, necessitating its removal by use of Cengar M.S. Cleaner. It is imperative that the saw is re-oiled immediately after... -
Page 8: Maintenance
4 Ensure that all valve mounting screws in the body are tight, and that air is not escaping from the gaskets at the front or rear. 5 Ensure the oil container is filled with Cengar Green Oil, leaving a small air bubble to prevent ‘Hydraulic Lock’. - Page 9 OILER MECHANISM ADJUSTMENT The oiler is preset at the factory, and should not need attention, but slight adjustment can be made if desired. Always ensure adequate lubrication. The jet is screwed in to be level with the end of the body. Tightening clockwise will reduce oil flow, and unscrewing anti- clockwise will increase the oil flow.
- Page 10 NEVER hold the Cengar saw in a vice by the body, this will distort the bores, rendering the tool inoperative. NEVER screw nameplates to the body, as the screws may penetrate an airway or bore.
-
Page 11: Saw Blades
A range of 19 mm deep blades could be fitted in certain circumstances. Replace the nosepiece 5045 with 5075 to use 19 mm blades Cengar Green Oil GO 9107P Cengar Green Oil 250 ml plastic bottles for all air tools GO 9109 As above in 5 litre container GO 9110 As above in 25 litre container M.S. - Page 12 SERVICE We offer a full factory repair and refurbishment service for Cengar Saws, - normally within 5 working days. Quotations at no charge can be given before work is carried out. DISTRIBUTOR ADDRESS Cengar Ltd. 70 Lister Lane Halifax, England . HX1 5DN Tel: 01422 354626 Fax: 01422 349024 enquiries@cengar.com...