We recommend normal safe working prac ces Work Act, or the appropriate Na onal and State should be followed as per the Health and Safety at Laws. We recommend that eye and ear protec on Work Act. We recommend that Eye protec on be be worn when using Cengar Saws worn when using Cengar Saws SPECIFICATIONS Speed 1200 strokes per minute Stroke 45 mm Air Consump on 0.168m...
Page 4
Be safe LUBRICATION Use Cengar Green Oil with longer las ng coa ng proper es for best results. Cengar Green Oil is specially prepared to: ‐ Emulsify the water generally found in compressed air lines. Give perfect mist lubrica on.
firmly abu ed to the work piece, with forward hand pressure, to prevent judder. Allow the Cengar Saw to cut under its own weight, with just a slight downward hand pressure to keep the teeth engaged in the cut. It is not necessary to put excessive downward pressure on the saw, this only accelerates blade wear, and prevents the saw from opera ng efficiently.
Page 10
IF THE SAW DOES NOT OPERATE Check that the isolator is switched on. Check air supply is correct. Valve in handle (part no. 50034) could be worn and/or the seal is broken, blocking an air passage. Check and replace if necessary.
Page 11
PIPE CUTTING WITH THE CL50 & 75 A clamp kit can be fi ed to the CL saws, (Part No CCSG3) allowing the machine to mount on pipes and sec ons. To fit the parts required on the saw: ‐ remove the nosepiece and silencer Fit the carrier over the front end tube, all the way to the back, and clamp ght with the Allen key provided.
Page 12
NEVER hold the Cengar saw in a vice by the body, this will distort the bores, rendering the tool inopera ve. NEVER screw nameplates to the body, as the screws may penetrate an airway or bore.
Page 13
Power Feed Clamp Kits Allows Cengar CL75 and JSZ saws to be used hands‐free, to accurately cut pipes and sec ons up to the capacity of the machine. The force applied is infinitely variable, and can be altered during the cut to allow for varying thicknesses of material.
Page 14
Op onal extras 9507CFA Op onal fall arrester plug to a ach to spring balance 1139FA Op onal Fall Arrester Bracket to a ach to spring balance LUB01 Op onal In‐Line lubricator 28cc capacity, runs full day per fill...
GO 9107P Cengar Green Oil 250 ml plas c bo les for all air tools GO 9109 As above in 5 litre container GO 9110 As above in 25 litre container M.S. Cleaner MS 9105 1 litre General purpose cleaning fluid for air tools.
Page 16
SERVICE We offer a full factory repair and refurbishment service for Cengar Saws, ‐ normally within 5 working days. Quota ons at no charge can be given before work is carried out. DISTRIBUTOR ADDRESS Cengar. Ltd. Springfield Works, Saddleworth Road Halifax, England HX4 8LZ Tel: 01422 377904 Fax: 01422 377161 enquiries@cengar.com...