Table of Contents
Advertisement
Installing the phone
Installing the Handset Battery
Inserting the batteries
Open the battery compartment cover. Put in the batteries. Close the battery
compartment cover.
a
Attention : : Use only power adaptors and batteries supplied with this
product. To order a replacement please call Customer support :
1-877-768-9483 or online: www.emersonphones.com
Charging the batteries
Before the handset is used for the first time, insert it in the base
station / charging station for at least 16 hours.
The handset warms up during the charging process. This is normal and
does not represent a risk. The battery status is shown on the display. When the
battery capacity is nearly exhausted, the battery symbol will flash in the display.
End your call and place the handset into the base or charging station for
charging.
After a short time, the battery symbol will appear to be fully charged but this is
actually not the case. The battery capacity will decrease rapidly. We advise
you to put the handset on the base unit for 12 hours so that it can be
recharged completely.
Base station
Choose an area near an electrical outlet and a telephone wall jack (RJ11C), and place
1.
your cordless telephone on a level surface, such as a desktop or tabletop, or you may
mount it on the wall.
Main power outlet
Plug one end of the telephone line cord into the TEL LINE jack on the back of the base
2.
and the other end into a modular jack.
3. Plug the AC power converter into the electrical outlet and the DC connector into the
jack on the back of the base.
4. Place the handset in the base cradle. The charge/in use voicemail indicator turns on,
verifying the battery is charging.
Install two "AAA"
size batteries
Replace the
cover
Modular phone wall jack
7
Basic operation
Answering a call
Press the
button, to answer a call.
TALK
Making a call
Enter the phone number, using telephone key pad. Delete wrong characters by pressing
the
button. Press and HOLD the
MUTE
MUTE
Press the
button , and the phone number is being dialed.
TALK
You can also press the
TALK
button, and you will hear the dialing tone. The entered
number will be dialed immediately. It is not possible to correct wrong digits individually
using this dialing procedure.
Ending a call
Press the
button or replace the handset in the base station.
TALK
Call timer
Your handset automatically times the duration of every call.
Activating handsfree
During a call operation you can switch On/Off the speaker.
Press the
button. The
appears in the display when the speaker is ON.
CID
Setting the speaker volume
Press the
button.
VOLUME
During a call you can adjust the volume from 1 to 5.
Muting the microphone
Press the
MUTE
button.
During a call you can switch your handset's microphone off. The display shows
To unmute press the
MUTE
again.
Redial
Your handset saves the last 3 dialed telephone numbers
Viewing/dialing telephone numbers
The handset is in idle state
Press the
button repeatedly (if necessary) until the desired telephone number is
REDIAL
displayed.
Press the
button. The phone number is being dialed.
TALK
When you press the
button and hear the dialing tone, the very last dialed telephone
TALK
number is dialed by pressig the
button.
REDIAL
button to delete entire entry.
.
16
Advertisement
Table of Contents
