Equipment approval information Your telephone equipment is approved for connection to the Public Switched Telephone Network and is in compliance with parts 15 and 68, FCC Rules and Regulations and the Technical Requirements for Telephone Terminal Equipment published by ACTA. On the bottom of this equipment is a label indicating, among other information, the US number and Ringer Equivalence Number (REN) for the equipment.
Should you have any questions or problems concerning this product, please contact our customer service department at: 1-877-768-8483 (Toll Free) Monday - Thursday: 9AM - 5PM (EST) Friday: 9AM - 3PM (EST) via e-mail at firstname.lastname@example.org Warranty service not provided This warranty does not cover damage resulting from accident, misuse, abuse, improper installation or operation, lack of reasonable care, and unauthorized modification.
WARNING TO PREVENT FIRE OR ELECTRICAL SHOCK HAZARD THIS PRODUCT TO RAIN OR MOISTURE CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with WARNING TO REDUCE THE RISK arrowhead symbol, within OF ELECTRIC SHOCK DO NOT an equilateral triangle, is REMOVE COVER OR BACK intended to alert the user...
● Answering system memory may be full. Erase some messages. ● You may have accidently pressed the play/stop button during playback and stopped the message. Won’t respond to remote commands ● You must use a tone-dial phone. This phone does not support pulse (rotary) dialing.
Location of controls Handset layout 1. Display 2. Talk / End 3. Scroll left / Flash 4. Phone Book 5. Menu / OK 6. Handset ringer ON/OFF 7. Ring tone volume 8. Earpiece 9. Speaker ON/OFF; CID; Scroll right 10. Mute 11.
Storing telephone numbers When the desired telephone number is displayed, press the TO PB if necessary and press the button. Enter the name and press the MENU button. Edit the telephone number if necessary. Press the last character or press and HOLD for deleting the whole number. You can enter a dialing pause (approximately 3 seconds) by pressing the PAUSE Press the...
Installing the phone Installing the Handset Battery Inserting the batteries Open the battery compartment cover, install the battery and replace the battery cover. Attention : : Use only power adaptors and batteries supplied with this product. To order a replacement please call customer support : 1-877-768-9483 or online: www.emersonphones.com Charging the batteries Before the handset is used for the first time, insert it in the base...
Area code Press the button. Select HANDSET using MENU Select AREA CODE using and press the MENU key pad and confirm with the button. MENU Phonebook You can store up to 50 entries in the phonebook. Storing an entry The handset in the idle state. Press the button.
Playback messages / deleting messages Press button. The messages will be played one after the other. If there are new messages, only these will be played. During playback Press button to go to the beginning of the current message. Press button twice to go to the previous message.
Handset name In the idle state the handset name and the internal telephone number is shown in the display. Press the button. Select HANDSET using MENU Using select HANDSET NAME and press the using . Enter the new name using the digit keys and press the MUTE Key tone The key tone is an acoustical confirmation for a pressed button.
NOTE: Depending on (a) how the incoming caller’s phone number is formatted when it is received, and (b) whether or not you previously pre-programmed your local area code into the set up menu, you may need to adjust the format of the incoming caller’s stored phone number, before making the call, press the button to adjust the number, and try again.