Operating Instructions; Shut Down - JET USA rx550 User Manual

RX550 Electric Pressure Washer

Operating Instructions

This unit is to be connected to a cold water source only.
The motor runs only when the trigger is squeezed.
1. Connect the outlet hose to the washer and connect the spray gun to the outlet hose.
2. Connect the nozzle and nozzle extension.
3. Check that the gauze filter is clear of any blockage.
4. Connect the water supply hose.
5. Check that the hose has no kinks in it.
6. Turn on the water and check for leaks.
7. Depress the trigger to allow air to be expelled though the pump and hoses, then lock the trigger.
8. Connect the machine to the electrical supply and switch the machine ON.
9. Unlock the trigger and use the pressure washer.

Shut Down

1. Switch the machine OFF (place switch to the off position).
2. Unplug the unit from the power source.
3. Turn off the water supply.
4. Press the trigger of the gun to depressurise the system.
5. Disconnect the garden hose from the pressure washer.
6. Wipe all surfaces of the unit with a damp clean cloth.
7. Engage the gun safety lock.
Always switch the machine OFF before turning off the water supply. Serious damage could
occur to the motor if the unit is run without water.
Never disconnect the high-pressure discharge hose from the machine while the system is still
pressurised. To depressurise the unit, turn off the motor, turn off the water supply and
squeeze the trigger 2-3 times.
E&OE ©2018 Jet USA 6