Advertisement
Quick Links
Advertisement
Related Manuals for JET USA RX550i
Summary of Contents for JET USA RX550i
- Page 1 RX550i...
- Page 3 Thanks for purchasing our latest portable pressure washer. Whether it be for light rinsing or for power stripping, this pressure washer is built for quick and easy high speed cleaning. To get the most out of your purchase, please read the manual before use.
- Page 4 This pressure washer is designed for very specific applications. Do not modify or use it for any application other than for which it is designed. • Never operate when there is: - a noticeable change in engine speed. - a noticeable loss of pressure - an engine misfire.
- Page 5 • Use both hands to control the wand. • Do not allow the hose to come in contact with the hot muffler. • Do not touch the nozzle or water spray while operating. Water spray must never be directed towards any electric wiring or directly towards the pressure washer.
- Page 6 The motor on this pressure washer does not run continuously. It only runs when the trigger of the spray gun is squeezed. After following the start up procedures in this manual, turn the pressure washer on and squeeze the trigger for activation. It is very important to bleed the gun before using the pressure washer.
- Page 7 This unit is to be connected to a cold water source only The motor of this pressure washer will not run, it will only operate when the trigger is squeezed. Connect the outlet hose to the washer and connect the spray gun to the outlet hose.
- Page 8 Turn off the spray lance Hold the rear part of spray nozzle, then turn the front part of spray nozzle clockwise, Water will sprayout from the spray nozzle in fan shapes (fig 1); Turn out the front part of the spray nozzle anti-clockwise for water to be sprayed more linearly (fig 2).
- Page 9 The water inlet filter must be inspected regularly, so as to avoid blockage and restriction in the water supply to the pump (fig 5). Fig 6. Fig 7. Add detergent to the container. Set the Adjustable Spray Wand at low pressure position. (fig 6) Trigger gun to spray detergent.
- Page 10 The connections on the pressure washer hoses, gun and spray wand should be cleaned regularly and lubricated with the manufacturer’s recommended grease to prevent leakage and damage to the O Rings. Clogging of the nozzle will cause the pump pressure to be too high. If the nozzle is clogged, clean it immediately.
- Page 11 If you must store your pressure washer in a location where the temperature is below freezing, you can minimise the chance of damage to your washer with the following instructions. 1. Shut off the water supply and relieve pressure in the spray gun by depressing the trigger.
- Page 12 Fault Probable Cause Repair Pressure washer isn’t working Plug is not connected or electric Check plug and socket socket is faulty Main voltage is insufficient and lower Check that the main voltage is than the minimum requirement adequate Thermal safety switch has tripped Switch off the unit and let the motor cool for a few minutes Fluctutating Pressure...
- Page 13 Hose Length Working Pressure 150 Bar Max. Pressure 262 B Working Flow Rate 7 L/Min Max. Flow Rate 8.7 1/Min Max. Pressure Water Supply 0.4MPa (4bar) Motor Capacity 2.5KW Power Supply Voltage 240V~50Hz LPA (sound pressure) 71dB(A), K=3 dB (A) LWA (acoustic power) 86 dB(A) Vibration Value...
- Page 14 Part Pressure Cleaner Water Supply Hose (Not Included) Water Connection Water Inlet High Pressure Tube Water Outlet Spray Gun Power Supply Portable Pressure Washer...