Adjust The Pet Area To Desired Size - Premier GIF00-16347 Product Manual

Adjust the Pet Area to Desired Size

Make sure the entire pet area lies within your property boundaries (3A). Always start
determining the boundary zone at the shortest distance from fence transmitter. Place
the boundary switch/range on Low (-) if the boundary zone will be less than 45 ft. from
the fence transmitter.
Make sure the receiver collar battery is properly installed, the static correction level is set
at 2 or greater, and the test light contacts are touching the contact points (3B).
NOTE: If your next-door neighbor has an in-ground containment system, see
"Troubleshooting" section.
Test Light Instructions
1. Set the correction level to 2 or above.
2. Hold the test light contacts to the contact points.
3. Walk toward the boundary zone holding the receiver collar at your pet's neck level
until the test light flashes. Save test light for future testing.
NOTE: If the test light does not flash, install a new battery and re-test. If test light still does
not flash, contact the Customer Care Center.
To maximize your pet area, make sure the boundary switch/range is on High (+)
and the boundary control dial is set to 8. Plug power adapter into power jack and
standard outlet.
Two-Person Method
Hold the receiver collar at your pet's neck height (3C) with logo
side facing away from the fence transmitter and contact points
facing upwards. Walk to the edge of the desired pet area. Facing
away from the fence transmitter, hold the receiver collar at the
edge of the desired pet area (3D). Starting with the boundary
control dial set to 8, have a second person turn the dial down
SLOWLY. When the receiver collar starts to beep, tell the person to
stop turning the boundary control dial. Record your settings below
for future reference.
One-Person Method
Measure the shortest distance from the desired boundary zone to the fence transmitter. Find the distance on the
fence transmitter range chart and set the boundary switch/range and boundary control dial. Hold the test light
contacts to the contact points (3B). Take the receiver collar to the boundary zone with the logo side facing away
from the fence transmitter and contact points facing upwards (3C). Hold the receiver collar at your pet's neck
level (3D) until the receiver collar beeps and the test light flashes. If the receiver collar beeps before or after the
desired boundary zone, return to the fence transmitter and adjust the boundary control dial. Repeat this process
until the receiver collar is beeping at the desired location. Record your settings for future reference.
8
3C
+1 (866) 381-2785
3A
Pet
Area
3B
3D
Pet
Area