Table of Contents
Advertisement
European Notice
Products with the CE Marking comply with both the EMC Directive (89/336/EEC) and the Low Voltage Directive (73/23/
EEC) and R&TTE Directive (1999/5/EC) issued by the Commission of the European Community.
Compliance with these directives implies conformity to the following European Norms:
•
EN55022 : 1998+A1: 2000+A2: 2003, CLASS B
•
EN61000-3-2 : 2000
•
EN61000-3-3 : 1995+A1: 2001
•
EN55024 : 1998+A1 : 2001+A1: 2003
•
IEC61000-4-2: 2001
•
IEC61000-4-3:2002+A1:2002
•
IEC61000-4-4:1995+A1:2000+A2:2001
•
IEC61000-4-5:2001
•
IEC61000-4-6:2001
•
IEC61000-4-8:2001
•
IEC61000-4-11:2001
•
EN50082 (IEC801-2, IEC801-3, IEC801-4) Electro-magnetic Immunity
•
EN 300 328-2, EN 300 328-1, EN 301 489-1, EN 301 489-17 (ETSI 300 328, ETSI 301 489) Electro-magnetic
Compatibility and Radio Spectrum Matter.
•
TBR21 ( ETSI TBR21) Terminal Equipment.
•
EN60950 (IEC950) I.T.E. Product Safety
REN (Ringer Equivalent Numbers) Statement
NOTICE: The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the maximum
number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of
any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the
devices does not exceed 5.
IC ID: 3409A-M30EI0
Attachment Limitations Statement
''Notice: This equipment meets telecommunications network protective, operational and safety requirements as pre-
scribed in the appropriate Terminal Equipment Technical Requirements document(s). This is confirmed by marking the
equipment with the Industry Canada certification number. The Department does not guarantee the equipment will
operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed using an acceptable method of connection. The
customer should be aware that compliance with the above conditions may not prevent degradation of service in some
situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or
alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company
cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines
and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important
in rural areas.
PRESTIGIO AVANTI 1770W
41
Advertisement
Table of Contents
