Bay 5 Operating & Installation Instructions Manual page 15

INSTALLATION INSTRUCTIONS
5. SECURE THE CASING TO THE WALL
Secure the casing in the opening by inserting screws, as shown on the
diagram. The stove can be screwed down through the base or through the
sides as required.
6. FILL WITH INSULATION AND MAKE GOOD THE OPENINGS
If you are using the vermiculite method of insulating the convection casing,
pour down from the top of the chimney. Fill in the space between the
casing and the brickwork and around the flue pipe with a vermiculite or
perlite concrete mix (see fig. 12). The recommended mixture is 6 parts of
vermiculite or perlite to 1 part cement. Add only enough water so that a
few drops are released when a handful of the mixture is squeezed.
Make good the opening at the top and sides of the convection casing
ensuring that a good seal is made with the side flanges. It is recommended
to use heat resistant plaster on the wall surrounding the stove.
If for any reason it is not going to be possible to sweep the chimney
through the appliance, a soot door must be fitted.
7. SLIDE IN THE STOVE
For the Bay 5GT, remove the RH fan by undoing
the two retaining screws. Move the stove into the
position shown and attach the free wire on the
inside of the convection casing to the pins
marked "pwr" +12V on the circuit board located
below the LH fan. Attach the LH fan wire to the
PCB.
Carefully slide the stove into the convection
casing until the flue outlet lines up with the upper
flue collar and the air inlet engages at the base of
the stove.
inserting screws at any of these points
Roller
Washer
M8x17
'R' Pin
1.7mm
9. FIT THE DOOR
Carefully lift the door onto the lower hinge pin and
insert the upper hinge pin through the hinge post
and the door
15
charnwood
BAY
Attach convection casing to wall by
8. INSERT COACH BOLTS
From the inside of the stove,
insert coach bolts in to slots A
and B so that they hang down
into the stove. These are held in
place by the clips and will secure
the flue collar.
A
ATTACHING THE
ROLLERS
Clevis Pin
(welded inside
Slot the roller and washer
stove)
over the clevis pin. Insert 'R'
pin through the clevis pin.
®
B