Bay 5 Operating & Installation Instructions Manual

Charnwood

Advertisement

Quick Links

®
charnwood
BAY
5/5GT/5VL
Operating & Installation Instructions

Advertisement

Table of Contents
loading

Summary of Contents for Bay 5

  • Page 1 ® charnwood 5/5GT/5VL Operating & Installation Instructions...
  • Page 3: Table Of Contents

    Hearth and Fire Surround Preparation of Fireplace Connecting the Fans Air Supply Fitting the Stove and Flue Pipe 14-16 Fitting the Optional Base Assembly Pre-lighting Check Commissioning CAA &Smoke Control 17-18 Dimensions 19-21 Parts Lists 22-24 Certification REF. Bay 5,5GT, VL v1 06.15...
  • Page 4: Quick Guide

    Pull handle in and out to riddle. See page 6 for more detail. Fan switch (Bay 5GT only) The fan turns on automatically. Bay 5GT See page 5 for more detail. Unsuitable fuels: Suitable fuels for your Charnwood: Smokeless fuels...
  • Page 5: General

    FAN OPERATION The door handle has been carefully designed so that in normal use it The Bay 5GT has a convection fan for effective heat distribution to may be operated using bare hands. However, if you need to open the the room.
  • Page 6: Ash Clearance

    (Bay 5GT) or the top layer of ash cleared using the scoop provided (Bay 5 & Bay VL). For advice on how and when to empty the ashpan (Bay 5GT), see p8. RIDDLING GRATE (BAY 5GT)
  • Page 7: Lighting

    Fig. 5 Building up the fire Once the fire is up to temperature the airwash system will begin to work, so allow the fire to become hot before adjusting the air control to the required setting.
  • Page 8: Refuelling

    It is best to with hard objects as it will chip. The Bay 5 and Bay 5GT are finished refuel on to a hot bed of ash. If at this point the fire starts to die, the with high temperature paint.
  • Page 9: Throat Plate And Flueway Cleaning

    charnwood OPERATING INSTRUCTIONS ® THROAT PLATE AND CO ALARM FLUEWAY CLEANING Your installer should have fitted a CO alarm in the same room as the appliance. If the alarm sounds unexpectedly, follow the instructions It is important that the throat plate and all the stove flueways are kept given under “Fume Emission”...
  • Page 10: Troubleshooting

    charnwood TROUBLESHOOTING ® FIRE WILL NOT BURN FUME EMISSION Check that: Warning Note: a) the air inlet is not obstructed in any way, Properly installed and operated this appliance will not emit fumes. b) chimneys and flueways are clear, Occasional fumes from de-ashing and re-fuelling may occur. c) a suitable fuel is being used, Persistent fume emission is potentially dangerous and must not be d) there is an adequate air supply into the room,...
  • Page 11: Installation Instructions

    1.3mm (0.05 inches) water ensuring regular servicing and maintenance of the appliance and gauge (12.5 Pa). If it is found that there is excessive draw in the chimney system.
  • Page 12: Hearth And Fire Surround

    Calcium Silicate board is used (80mm board for Bay 5 & VL Min. 615mm Min. 410mm Min. 380mm Bay 5 & VL, 100mm board for Bay 5GT), with a 100mm air gap Max. 650mm Max. 440mm between the stove and the insulation (see Fig. 11). Min. 620mm Bay 5GT Min.
  • Page 13: Air Supply

    13. One end of the air supply ducting is connected to the stove and the other is terminated outside. The ducting must be 100mm dia, non-combustible, less than 5.5m long and must not have more than five 90° bends and two 45° elbows. It must be sleeved where it Lintel passes through the external wall.
  • Page 14: Fitting The Stove And Flue Pipe

    Slide the convection casing into position in the opening until the flue outlet lines up with the flue pipe. For the Bay 5GT, thread the free socket and wire for the fans on the outside of the convection casing through the conduit and insert convection casing into the opening.
  • Page 15 7. SLIDE IN THE STOVE 8. INSERT COACH BOLTS For the Bay 5GT, remove the RH fan by undoing From the inside of the stove, insert coach bolts in to slots A the two retaining screws.
  • Page 16 Sealed with 8mm self-adhesive rope seal Secure with nut here 10. ATTACHING THE BAY 5- 5GT FRAME Bay & Bay 5GT Finally, fit the frame to the front of the stove. First, hold the top and bottom pieces in place.
  • Page 17: Fitting The Optional Base Assembly

    FITTING THE OPTIONAL BASE ASSEMBLY 2. The plates round the sides and back of the grate must be in BAY 5 & 5GT position and sitting correctly. 3. The throat plate must be fitted in the roof of the appliance (as 1.
  • Page 18 Order made and signed by the Secretary of State or Minister in the devolved administrations. The Charnwood Bay 5 & Bay 5GT have been recommended as suitable for use in smoke control areas when burning wood logs.
  • Page 19: Dimensions

    Bay 5 DIMENSIONS (mm) ® FRONT VIEW BACK VIEW ø155 (for a 6" flue) ø100 PLAN VIEW SIDE VIEW Note: Door extends a maximum of 573mm from front of stove when open. FRONT VIEW WITH FIREPLACE TRIM...
  • Page 20 Bay 5VL (mm) ® FRONT VIEW BACK VIEW (for a 6" flue) PLAN VIEW SIDE VIEW Note: Door extends a maximum of 573mm from front of stove when open.
  • Page 21: Dimensions

    Bay 5GT DIMENSIONS (mm) ® FRONT VIEW BACK VIEW ø155 (for a 6" flue) ø100 PLAN VIEW SIDE VIEW Note: Door extends a maximum of 573mm from front of stove when open. FRONT VIEW WITH FIREPLACE TRIM...
  • Page 22: Parts Lists

    Bay 5 PARTS LIST ® Issue D Item Part No. Description Item Part No. Description 001/XR010 Firebox 004/MR044 Latch Plate 002/XR001/A Door Assembly 002/XR020 Lower Hinge Bracket 006/MR019 Glass 010/XR011 Convection Casing 008/MR047 Handle Pivot Boss 004/MR060 Air Duct Cover...
  • Page 23 Bay 5VL PARTS LIST ® Issue A 28 13 16 15 35 34 44 42 43 14 Item Part No. Description Item Part No. Description 001/XR010 Firebox 008/XR012 Control Knob 004/XR072 Air Control Plate 002/BT001/A Door Assembly 006/BT018 Glass...
  • Page 24: Parts Lists

    Serial No Bracket 002/MR067 Air Control Knob 004/MR116 Serial Plate Carrier 010/MR024 Grate Cover Plate 012/MR014 Serial No Label 002/CG01S5 Set of Grate Bars (5) 010/MR096 LH Fan Assembly 002/CG01 Bottom Grate Bar 010/MR093 RH Fan Assembly 010/MR022 Carrier Bar 008/MR099...
  • Page 25: Certification

    Bishops Way, Newport, Isle of Wight PO30 5WS, United Kingdom A Division of A.J.Wells & Sons Limited Registered in England No. 03809371 EN13229:2001/A2:2004/AC:2007 INSET APPLIANCES INCLUDING OPEN FIRES FIRED BY SOLID FUELS Bay 5 Model Bay 5GT Bay 5VL EC Certificate of conformity no:...
  • Page 28 y o u r p r e m i e r d e a l e r charnwood BISHOPS WAY, NEWPORT, ISLE OF WIGHT PO30 5WS, UNITED KINGDOM T:+44 (0)1983 537777 • F:+44 (0)1983 537788 • CHARNWOOD@AJWELLS.CO.UK • WWW.CHARNWOOD.COM ® A D i v i s i o n o f A .

This manual is also suitable for:

5vl5gt

Table of Contents