Switching To Suspend Mode; Turning The Receiver Off - ashtech MobileMapper 100 Getting Started Manual

enough satellites are tracked, you can start using your
receiver and run your application software.
Switching to
Switching the receiver to Suspend mode is the right thing to
do when you need to make a short pause in your work. In
Suspend Mode
Suspend mode, the receiver is idle, using the minimum of
energy required to save the use context.
To switch to Suspend mode, just press briefly on the Power
button [8].
[8]
To wake up the receiver, hold the same button pressed ntil the
screen wakes up. This will instantly restore the use context in
which the receiver was before entering the Suspend mode.
Turning the
After you have finished your field work, turn off your receiver
by holding the Power button [8] pressed until the message
Receiver Off
"Saving Parameters.." is displayed on the screen.
The power shutdown will be effective after about 25 seconds.
Tapping OK in the upper-right corner of the screen will not
affect the progress of the power shutdown sequence but
simply close the message window. There is indeed no way of
shortening or canceling the power shutdown sequence.
6