Connecting To The Console Port - Mitel 2000 Series Hardware Installation Manual

1
Mobility Router 2000 Installation

Connecting to the Console Port

1.7 Connecting to the Console Port
The Mobility Router uses a serial console port to provide a direct connection to the command-line interface (CLI)
Wizard for initial configuration the Mobility Router. After completing the initial configuration, access to the
console port is no longer necessary.
To initially configure the Mobility Router, connect the management PC or laptop to the serial console port of the
Mobility Router. If there is no serial port, use a 9-pin serial to USB adapter to connect to the serial cable.
To connect the PC or laptop to the serial console port:
1
Insert one end of the serial cable into the PC or laptop serial port.
2
Insert the other end of the cable into the serial console port of the Mobility Router.
Figure 1-6. Connecting to the Serial Console Port
3
On the PC or laptop, start terminal emulation software (such as Microsoft HyperTerminal) and select the
appropriate COM port.
4
Configure the port using the following settings:





8
Baud rate: 9600 bps
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
Mobility Router 2000 Series Hardware Installation Guide