Whirlpool cabrio W10164751A Use & Care Manual page 76

Whirlpool Cabrio W10164752A Use & Care Manual (Page 14 of 52)
7. Check that the dryer is level. See "Level Dryer."
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
8. Plug into a grounded 3 prong outlet. Turn on power.
9. Remove any film or tape remaining on the dryer.
NOTE: Glass door models have a film on the window that
should be removed.
10. Read "Dryer Use."
11. Wipe the dryer drum interior thoroughly with a damp cloth to
remove any dust.
//static-data2.manualslib.com/manual/190510/Whirlpool-Cabrio-W10164752a.html?page=14 (2 of 7)3/20/2018 3:48:09 AM
WARNING
12. If you live in a hard water area, use of a water softener is
recommended to control the buildup of scale through the water
system in the dryer. Over time, the buildup of lime scale may clog
different parts of the water system, which will reduce product
performance. Excessive scale buildup may lead to the need for
certain part replacement or repair.
13. Test dryer operation by selecting a Timed Dry heated cycle and
starting the dryer. For this test, do not select the Air Only modifier.
If the dryer will not start, check the following:
Dryer is plugged into a grounded 3 prong outlet.
Electrical supply is connected.
Household fuse is intact and tight, or circuit breaker has not
tripped.
Dryer door is closed.
14. When the dryer has been running for 5 minutes, open the dryer
door and feel for heat. If you feel heat, cancel cycle and close
door. If you do not feel heat, turn off the dryer and check that the
gas supply line shutoff valve is open.
If the gas supply line shutoff valve is closed, open it, then
repeat the 5-minute test as outlined above.
If the gas supply line shutoff valve is open, contact a
qualified technician.