Table of Contents
Advertisement
Install Vent System; Install Leveling Legs; Make Gas Connection - Whirlpool Cabrio W10164752A Use & Care Manual [Page 10]
Install Vent System
1. Install exhaust hood. Use caulking compound to seal exterior wall
opening around exhaust hood.
2. Connect vent to exhaust hood. Vent must fit inside exhaust hood.
Secure vent to exhaust hood with 4" (102 mm) clamp.
3. Run vent to dryer location. Use the straightest path possible. See
"Determine vent path" in "Plan Vent System." Avoid 90º turns.
Use clamps to seal all joints. Do not use duct tape, screws, or
other fastening devices that extend into the interior of the vent to
secure vent, because they can catch lint.
10
Next page
Previous page
Dryer Whirlpool WGD6600W Dimensions And Installation Information
Gas dryer (1 page)
Dryer Whirlpool WGD6200S Product Dimensions
Gas dryer (1 page)
Dryer Whirlpool Cabrio W10164159A Use & Care Manual
Steam fabric care system electric dryer (56 pages)
//static-data2.manualslib.com/manual/190510/Whirlpool-Cabrio-W10164752a.html?page=10 (3 of 7)3/20/2018 3:44:01 AM
1 ... 6 7 8 9
10
Related Manuals for Whirlpool Cabrio W10164752A
Mobile home installations require a Mobile Home Installation Kit.
See "Tools and Parts" section for information on ordering.
Make Gas Connection
1. Remove the red cap from the gas pipe.
2. Using a wrench to tighten, connect the gas supply to the dryer.
Use pipe-joint compound on the threads of all non-flared male
fittings. If flexible metal tubing is used, be sure there are no kinks.
A. Flared male thread
B. Non-flared male thread
NOTE: For LP gas connections, you must use pipe-joint
compound resistant to the action of LP gas. Do not use
TEFLON
tape.
®†
†
®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.
Table of Contents
11 12 13 14
Advertisement
Advertisement
Table of Contents
