Control Panel - Dolmar GE-1100 Instruction Manual

(e) After 20 to 30 seconds of warm-up is completed, turn the engine switch to "
(f) Make sure the output lamp is on. This indicates that the generator is properly operating.
NOTE
Please consult with the authorized DOLMAR factory or authorized service center
if the output lamp is turned off during the proper operation.
2. USING ELECTRIC POWER
Make sure that the appliance is switched OFF before connecting it to the generator.
■ ■
GB
Do not move the generator while it is running.
■ ■
GB
Be sure to ground the generator if the connected appliance is grounded. Failure to
■ ■
GB
ground unit may lead to electrical shock.
GB

CONTROL PANEL

GB
GE-1100 (50Hz-230V)
GB
GB
1
GB
GB
GB
GB
GB
GB
GB
GB
GB
8
(1) AC APPLICATION (See Fig. 4 4 -r r )
(a) Make sure the output lamp is turned on.
(b) Turn off the switch(es) of the electrical appliance(s) before
connecting to the generator.
(c) Insert the plug(s) of the electrical appliance(s) into the receptacle.
Be sure to ground the generator if the connected
■ ■
electrical device is grounded.
Failure to ground unit could lead to electrical shock.
■ ■
8
WARNING
2
3
4
5
6
7
WARNING
RUN) position. (See Fig. 4 4 -e e )
"(
q OUTPUT LAMP
w OIL SENSOR LAMP
e AC RECEPTACLES
r AC CIRCUIT BREAKER
t DC TERMINALS
y DC CIRCUIT BREAKER
u GROUND TERMINAL
i ENGINE SWITCH