Making A Push 2 Talk Call By Entering A Number - Sanyo SCP-2300 User Manual

Making a Push 2 Talk Call by Entering a Number

To place a Push 2 Talk call by entering a number:
1.
From standby mode, enter the Push 2 Talk number you want
to dial.
2.
Press
to take the floor and speak.)
The contact's name appears on the display if there is a
matched number in your Push 2 Talk List.
3.
Continue with the Push 2 Talk call, pressing and holding
speak and releasing it to allow others to reply.
4.
When the call is finished, press
– or –
1. Press P2T (left softkey) or press
2. Press Go to (left softkey), highlight Enter P2T# and press
3.
Enter the Push 2 Talk number you want to dial.
4.
Follow steps 2-4 above.
Note:
Push 2 Talk numbers must contain ten digits (area code + phone number).
Your Push 2 Talk number is the same as your phone number.
to place the Push 2 Talk call. (Continue holding
.
.
to
.
95