About Applications; Axis People Counter - Axis P1447-LE User Manual

AXIS P14 Network Camera Series
Setup
3. Connect the I/O wire to pin 3 (I/O input).
Connect the wires to the PIR detector's I/O connector
1. Connect the other end of the ground wire to pin 1 (GND/-).
2. Connect the other end of the power wire to pin 2 (DC input/+).
3. Connect the other end of the I/O wire to pin 3 (I/O output).
Configure the I/O port in the camera's web page
1. Go to Settings > System > I/O ports.
2. Give the input module a descriptive name.
3. To make the PIR detector send a signal to the camera when it senses motion, select Closed circuit in the drop-down list.
To trigger the camera to start recording when it receives a signal from the PIR detector, you need to create an action rule in the
camera's web page.
Applications

About applications

AXIS Camera Application Platform (ACAP) is an open platform that enables third parties to develop analytics and other applications
for Axis products. To find out more about available applications, downloads, trials and licenses, go to axis.com/applications
To find the user manuals for Axis applications, go to axis.com
Note
• Several applications can run at the same time but some applications might not be compatible with each other. Certain
combinations of applications might require too much processing power or memory resources when run in parallel. Verify
that the applications work together before deployment.

AXIS People Counter

AXIS People Counter is an analytic application that can be installed on a network camera.
The counter is embedded in the camera which means you do not need a dedicated computer to run the application.
AXIS People Counter is intended for retail environments, like stores or shopping malls, or other environments where you want to
count people.
15