Applications - US Ultratek USB-UT350T User Manual

3 Applications

The USB-UT350 ultrasonic pulser/receiver and analog to digital converter can be used
for a variety of applications.
The device emits a negative high voltage pulse (or a series of tone burst pulses if the tone
burst pulser is installed) on the TX connector and receives the response signal through
either the TX connector or the RX connector depending on whether the device is in
pulse/echo or through transmission mode. The receiver clips off the high voltage portion
of the signal and performs amplification, filtration, and DC offset adjustment. The clean
signal is then digitized and available for analysis.
3-1
USB-UT350 User's Guide
Revision 1.77 – 09/30/2009