Yaesu FT-1500M Operating Manual page 22

Default Setting: OFF
Set Item [RPTER]
Function: Enable/Disable the Automatic Repeater Shift feature and Setting of the Repeater Shift
Direction
Available Values: ARS/Shift -/Shift +/OFF
Default Setting: ARS
Set Item [RVRT]
Function: Enable/Disable the "Priority Channel Revert" feature
Available Values: OFF/ON
Default Setting: OFF
Set Item [SCAN]
Function: Select the Scan Resume mode.
Available Values: BUSY/5SEC/HOLD
Default Setting: BUSY
Set Item [SHIFT]
Function: Set the magnitude of the Repeater Shift
Available Values: 0.00 ~ 99.95 MHz (only shifts of less than 4 MHz will work)
Default Setting: 600 kHz
Set Item [SKIP]
Function: Enable/Disable Skipping of a channel during scanning.
Available Values: SKIP/STOP
Default Setting: STOP (Stop on busy channel)
Set Item [SQL]
Function: Set the Squelch threshold
Available Values: OFF/1 ~ 15 (arbitrary scale)
Default Setting: 1
Set Item [STEP]
Function: Setting of the synthesizer steps used in VFO/Memory Tune operation.
Available Values: 5/10/12.5/15/20/25/50 kHz per step
Default Setting: 5 kHz
Set Item [S.SRCH]
Function: Select the Smart Search Sweep mode.
Available Values: Single/Continue
Default Setting: Single
Set Item [TONE]
Function: Select the CTCSS mode.
Available Values: OFF, T, TSQ
Default Setting: OFF
Set Item [TN FRQ]
Function: Setting of the CTCSS Tone Frequency.
Available Values: 39 standard CTCSS Tones
Default Setting: 100.0 Hz
Set Item [TOT]
Function: Set the time-out limit for the Time-Out Timer
Available Values: 1 ~ 60 minutes, or OFF
Default Setting: 6 minutes
Set Item [W/N DV]
Function: Reduction of the Microphone Gain/Deviation and receiver bandwidth
Available Values: WIDE/NARROW
Default Setting: WIDE (±5 kHz Deviation, 15 kHz bandwidth)