C63 Certified Flue Systems - Lochinvar HERALD HCB46CE Installation Manual

11.7.1 TYPICAL CONVENTIONAL FLUE ARRANGEMENT
11.8

C63 CERTIFIED FLUE SYSTEMS

In general, Boilers are certified with their own purpose supplied Concentric or Twin Pipe flue systems, C
appliances allow the installer to use other flue systems when installing the Boiler however, they must be of a suitable
minimum standard as per Table below.
CE string
flue gas
material
min. eis PP EN 14471
min. eis RVS EN 1856-1
11.8.1 C63
FLUE SYSTEM SPECIFICATION
Material Boiler
PP HCB46 CE
PP HCB61 CE
PP HCB86 CE
Aluminium flue pipe must not be used on this appliance as it may lead to premature failure of
the heat exchanger and will invalidate the warranty.
1.Insert the exhaust transition into the exhaust port of the boiler.
2..Insert the flue temperature sensor into the location hole on the exhaust
transition.
If the flue temperature sensor is not fitted, the flue gas may
exceed the maximum temperature rating of the flue and can
lead to severe personal injury, death or substantial property
damage.
3.Insert the air intake into the intake connection and tighten the worm drive clip.
4.Insert the air inlet grill into the air inlet transition. For safety reasons this must
be fitted prior to operating the appliance.
T120 P1 W 1
T120 P1 W 1
d D
nom outside
80 80 +/-0.6
80 80 +/-0.6
100 100 +/-0.6
O 30
L20040 O 40
d
inside
certified
63
I of E C/E L
L
insert
50 +20/ -2
50 +20/ -2
50 +20/ -2
40