Panasonic MINAS A5 Series Operating Instructions Manual page 15

3. System Configuration and Wiring
Wiring to the connector, X4
Wiring Example of Velocity Control Mode
Divider
Remarks X1 to X7 are used for the secondary circuit. To connect these terminals to the primary
power supply (particularly, the 24 VDC power supply for control, the 24 VDC power
supply for brake, and the 24 VDC power supply for regenerative resistor [for H-frame
only]), insulation is required. Do not connect these terminals to the same power supply.
− B28 −
3. System Configuration and Wiring
Wiring to the connector, X4
Wiring Example of Torque Control Mode
Divider
Remarks X1 to X7 are used for the secondary circuit. To connect these terminals to the primary
power supply (particularly, the 24 VDC power supply for control, the 24 VDC power
supply for brake, and the 24 VDC power supply for regenerative resistor [for H-frame
only]), insulation is required. Do not connect these terminals to the same power supply.
− B29 −