Safety 1st 08038 User Manual page 6

08038_inst_E_112103 12/10/03 2:01 PM Page 6
Installing Your Home Connection Monitor System
To Set Up the Baby's Units:
4. Locate each Baby's Unit and its AC
adapter. Connect the AC adapter
into the bottom of each Baby's
Unit (Figure 2). If desired, wrap the
excess cord onto cord shortener.
Connect the AC adapter into a
power outlet. Place the Baby's Unit
on a flat surface 4 to 6' (1.5 to 2 m)
away from the baby.
CAUTION: DO NOT use an adapter
that did not come with this product.
Choose Locations:
IMPORTANT: When choosing locations to set up the Baby's Units and Parent's Units
follow these guidelines:
• For best sound quality and safety, place each Baby's Unit 4 to 6' (1.5 to 2 m) away
from the baby.
• Be certain the Parent's Unit and Baby's Unit are set on the same channel (all Units
are preset on channel I when packaged).
• Check reception regularly.
• Adjust the volume to a comfortable level for your environment.
• Use each Parent's Unit far enough away from the Baby's Units so as not to get
feedback.
• During use of the monitor, if the sound quality deteriorates you may be reaching the
limits of the monitor's range. If this happens, you will need to move the Parent's Units
in closer proximity to the Baby's Units.
To Use the Baby's Unit and Parent's Units:
5. Turn each charged Parent's Unit and Baby's Units to the On position. Be sure that
channel I is selected on all Baby's Units.
NOTE: The channel selectors on the Parent's Units are preset to channel I. A
second channel is available if you experience interference. Please refer to the
Troubleshooting section.
6
2
Baby's Unit
AC
Adapter