Table of Contents
Advertisement
5. Press
to select desired minute
for *sign printing setting
6. Press ENTER button to confirm setting
7. Press
to select 01/02
for *sign printing setting
01: without * printing
02: with * printing
8. Press ENTER button to confirm setting
9. Now display turns to day setting (indicator flashing under Sunday)
Press ENTER button and the entire week will be set and skip to step 14.
Note: Use steps 10-13 for any days that you want to delete the setting
10. Press
to select the day
11. Press Symbol button once to delete selected day for * sign print.
12. Press
to move to next day and repeat step 11
Note: If you want to undelete the day, press
to choose the day to undelete, and press
the
SYMBOL
button to add the day back.
13.
After completing deleted days setting,
press
ENTER button to confirm setting
.
14. The setting number turns to 02. Repeat steps 2-13 (total of 24 settings allowed)
to continue next setting or slide SETUP button to the right to complete and exit setting
5.2 SETTING THE MUSIC ALERT
This feature is used to set the music bell to alert for shift change or breaks. The volume of
the internal speaker can be changed by using a small screwdriver to turn the
switch labeled Vol.
1. In setting mode, press MUSIC button to
enter music setting
3. Press
to select desired hour for music to begin
4. Press ENTER button to confirm setting
5. Press
to select desired minute for music to begin
6. Press ENTER button to confirm setting
7. Press ENTER again to select 01 for music bell
.
button
.
4.7 SETTING PRINTING POSITION - 07
This function is necessary only if adjustment is required to provide proper alignment of the
print position on the time card within the box outline on the time card . With the recorder
out of the SETUP mode (switch to the right), you will need to print a test card to determine
if the unit is printing properly within the box. If the alignment is acceptable, please ignore
the following instructions, otherwise proceed.
07
* Increasing the number (00-15) will more the
print up on the card.
4. Press ENTER button to confirm setting
*Increasing the number (00-30) will move the print to the right
6. Press ENTER button to confirm setting
7. The setting number now turns to 08
8. Continue to next feature set up or slide the SETUP button to
the right complete and exit setting mode
4.8 SETTING ON/OFF FUNCTION FOR AUTO-
DETECTING TIME CARD - 08
Because the time card is double sided, this auto-detection feature assures that the
time card is inserted on the correct side that corresponds to the date printed on
the time card. If the time card is put in backwards, it will not print but be ejected
until the opposite side is inserted. Auto-detection (00) is recommended.
08
.
.
Hide quick links:
Advertisement
Table of Contents
