Table of Contents
Advertisement
Vibration Alarm Setup
Format: #ZDBJ # sensitivity (1-15
Sensitivity "1" is the most sensitive and of course "15" is the most insensitive.
Alarm mode"0' indicates vibration alarm is closed.
Alarm mode"1" indicates the device will alarm you through calls or SMS.
Note: SMS will be sent only when the device is online on the tracking system.
For example: If you set #ZDBJ#1#1#, the device will send you back "Config OK The Vibrate Warning Is: 1 1"
That means that the tracker is in a most sensitive status and alarm by calls.
Cut oil supply by SMS
Format: #DY# password # state #
The value of state is "0" and "1","1" is cut off oil, "0" is restore oil
Example: #DY#000000#1#
For safety, this command will be function when the speed less than 5KM/h
After sending command successfully, the tracker will return a message "config OK" and cut oil supply of the vehicle.
Low Battery Alert Setup
Format: #DDBJ# state #
The value of state is "0" and "1","1" means "open low battery alert", "0" means "close low battery alert".
Example: #DDBJ#1#
After sending command successfully, the tracker will return a message "config OK Low Battery Alert Is: On".
Over-speed Alarm Setup
Format: #CSBJ# speed limit (km/h) # state #
）
# alarm mode (0,1 )#
Advertisement
Table of Contents
