Troubleshooting - JVC LT-42DR9BJ Manual

Troubleshooting

Messages
Is the TV connected correctly to the aerial?
Change the direction of the indoor aerial.
Is there a digital channels transmission tower nearby?
gTurn "Attenuator" to "On".
INSTRUCTIONS
"Attenuator" (P. 30)
"Missing or
weak signal"
Check digital channels signal with "Signal Check".
(P. 15)
If you still cannot watch the digital channels after
following the steps above, there may be a problem with
your aerial or its cable. Or, the signal may be too weak.
Consult your retailer.
g
When "Dolby Digital" is selected in "Digital Audio
Output", the sound of a programme containing "Dolby
Digital" signals cannot be output from the TV or the
audio system connected to the AUDIO OUT
"Dolby Digital
terminal. (P. 18)
selected!
When the channel is changed, a message will be
No analogue
displayed for a few seconds.
audio available"
To listen with the TV or audio system
Select a language without "Dolby" from "Audio
g
Selection". (P. 5)
Switch "Digital Audio Output" to "PCM". (P. 13)
g
"Services have Update the PR List (digital channels)
changed. Do "Updating the PR List" (P. 17)
g
you want to If the message appears even though PR List updating
Update PR is not required, set "Receiver Upgrade" to "Manual" to
list?" cancel the reception test at midnight. (P. 13)
The message appears when you perform operations
related to the digital channels while a "Record" timer is
"Stop
in progress. Press the "TV/DTV" button to continue
Recording?"
recording or press the "OK" button to stop the
recording.
Actions Messages
"No Recording"
A problem occurs at the recorder.
(T-V LINK)
"No Recording
The recorder is not ready for recording.
Media Problem"
Check the videotape or DVD disc.
(T-V LINK)
"No Recording
The recorder is recording another programme, or is
Device Busy"
playing.
(T-V LINK)
Actions
16