JVC LT-42DR9BJ Manual page 11

3
Set the timer
Timer
PR
1 : BBC ONE 17 : 15 18 : 00 05/05 /2008 Once
(red) Record
TV
A message will be displayed if there is problem with the reservation.
When you reserved the programme using EPG, EPG will be displayed.
When "Remind" timer is set, "End" will be displayed as "----".
Cancel a reservation
select
(green)
Change a reservation
A select
B display the menu
14:00 05/05/2008
Start End Date Mode
(blue) Remind
Radio
A select "Yes"
B cancel reservation
Change the settings.
4
Prepare for recording before the timer starts
Set the recording device as follows. At the start time, the
Record
programme will be output from the EXT-2 terminal to the
recording device.
If you use a "T-V LINK" compatible device, set it to the external input
mode then to the standby mode. At the start time, the device will start
recording automatically. Make sure the recording times of other
recordings on the recording device do not overlap with recording times
on the TV. Some "T-V LINK" devices may not work correctly. It is
recommended to do a recording test.
"T-V LINK" compatible device refers to device with any of the
following logos.
"T-V LINK" (JVC), "Q-LINK" (Panasonic), "Megalogic" (Grundig),
"Data Logic" (Metz), "SMARTLINK" (Sony), "Easy Link" (Philips)
Connect the "T-V LINK" compatible device to the EXT-2 terminal
using a fully wired SCART cable.
If error message appears on the TV screen, refer to
"Troubleshooting" (P. 16).
If you use a "T-V LINK" incompatible device, manually set the device's
timer to record the external input at the same recording times set on the
TV. For details, refer to the device's manual.
When the TV is on, the power lamp on the TV will start blinking 3
minutes before the start time and a message "Timer Starting Soon"
appears on the screen.
At the start time, the power lamp will light up and the message will be
cleared. However, if the "Power Lamp" is set to "Off", the power lamp
will not blink nor light. (Refer to "Power Lamp" (P. 29) on the user
manual "INSTRUCTIONS".)
When the TV is off, the power lamp will start blinking 3 minutes before
the start time. The power lamp will light up at the start time and goes
out at the end time.
To stop the recording while a "Record" timer is in progress, press "
to display the message "Stop Recording?". Then press the "OK" button.
The "Remind" timer does not turn the TV on or off. Turn the
Remind
TV on before the timer starts. At the start time, a message
"Reminder Changing PR" will appear and the channel will
automatically change.
"
11