Setup - JVC LT-42DR9BJ Manual

Setup

14:00 05/05/2008
Digital Audio Output PCM
Banner Duration 2 sec
Auto
Receiver Upgrade
Common Interface No CI Module
Off
Antenna Power
Navigate Select MENU Exit
Digital Audio Output Output the digital signal from the DIGITAL
AUDIO OUT terminal.
PCM : The Linear PCM signal is output
Dolby Digital: The Dolby digital signal is output when the Dolby Digital
signal is received
Please read ""Dolby Digital" output from the DIGITAL AUDIO OUT
terminal" (P. 18) before setting.
Banner Duration Select the display time for channel information
(2 sec / 5 sec / 8 sec)
Receiver Upgrade
The TV will automatically search for new tuner software and run the
reception test (for digital channels) at midnight (3 AM) on a daily basis.
You can select the desired operation with this setting.
The Receiver Upgrade function works only when the TV is off (standby).
If new software is available, the TV will automatically download and
upgrade the tuner software.
If the TV detects channels that became receivable or if the TV was not
able to receive a certain channel, a message about updating the PR
List will be displayed when the TV is turned on.
"Updating the PR List (Digital channel only)" (P. 17)
g
Auto : The search for new software and the reception test will operate
at midnight. In addition, the TV will start searching for new
software whenever the TV is turned off. Normally set to "Auto".
Setup
Manual : Only the search for new software will operate at midnight. The
reception test will not be run. In addition, you can start
searching for new software whenever you want.
To start searching, select "Manual" and press "OK" button.
Software Version
0.31.01
OK Search for new
Select "Search for new" and press "OK" button. Then, follow
the instructions on the screen.
In standby : Upgrade the software automatically when the TV
is turned off.
Common Interface
To watch pay-TV digital channels, use the CAM (Conditional Access
Module) menu. This function can only be used when pay-TV can be
received in your region.
When the CAM etc. is inserted after subscribing to the broadcasting
company, this function is available.
"Watch pay-TV digital channels"
If the CAM etc. is not inserted, "No CI Module" will be displayed and
this function cannot be used.
Press "OK" button to display the CAM menu and follow the instructions on
the screen.
The content of the menu is different depending on the broadcasting
company.
For details, consult your broadcasting company.
g
The language shown in the menu may differ from the "Language" set
for the TV.
Antenna Power
When using an indoor aerial which requires external power, set
"Antenna Power" to "On".
The TV will supply DC 5V, 50mA (max) from the aerial socket through the
cable to the aerial.
"Power supply for the indoor aerial"
INSTRUCTIONS
g
P. 8
INSTRUCTIONS
g
P. 12
13