Philips HTS5506/F7 Service Manual page 24

Blu-ray disc home theater

Hide thumbs Also See for HTS5506/F7:

Table of Contents

4-6. Data write begins. While writing data, the Status Display message will change.

SEND LD PAR

4-7. [OK] appears in the Status Display if data write has been completed successfully.

If error occurs:

• If an error occurs, the screen changes to a red display. In such case, close the window and then unplug the

unit AC power cord. Check if each device is properly connected then repeat from step 1.

• If an error other than connection error occurs for more than 3 times, the BD MAIN CBA or BD Mechanism

Assembly may be defected. Replace with a new one before performing the OPU DATA write.

4-8. After data write has been completed successfully, unplug the AC power cord.

4-9. Remove the FFC Cable of COMTOOL jig relay board connected to the BD Main CBA.

Then disconnect all devices connected to the unit.

Status Display

1-8-4

B4(3D)_HT_AIR

Table of Contents