Hitachi CP-WX11000 Service Manual page 39

11. Fix the ange-back adjustment (1)
To x the focus after ange-back
adjustment, use the large hexagon pin to
tighten the temporary xing screw on the
top.
12. Fix the ange-back adjustment (2)
Remove the lens, which is xed
temporarily with the screw on the top,
and place it on a soft cloth or similar.
Tighten the temporary xing screw on the
underside in the same way.
13. Fix the ange-back adjustment (3)
Using the small hexagon pin, tighten the
three setscrews on the lens body.
14. Fix the ange-back adjustment (4)
Mount the xing ring on the lens and
screw on. Mount the xing ring with the
threaded side facing down.
15. Fix the ange-back adjustment (5)
Tighten the setscrew on the xing ring.
16. Install the lens
Follow the procedure in Attaching the
Lens to complete installation of the lens
in the LCD projector.
(The two blinders and two protectors are
not supplied with the USL-801 lens.)
CP-WX11000 ( P6WX )
Temporary xing screw
(one on the top)
FB adjustment pin
Temporary xing
screw (underside)
Three setscrews
Lens body
Fixing ring
Fixing ring
One setscrew
39