Page 1
ORIGINAL INSTRUCTIONS Petrol Brushcutter RBC254SSEON...
Page 2
Important! It is essential that you read the instructions in this manual before assembling, operating, and maintaining the product. Subject to technical modification.
Do not use cutting means or attachments, which are ■ Do not start or run the engine in a closed or poorly not specified by RYOBI in this manual. This includes ventilated area; breathing exhaust fumes can kill. the use of metal multi-piece pivoting chains and flail- blades.
areas where it is difficult to see the material being cut. WARNING ■ For cutting ease and safety, approach the weeds being Inspection after dropping or other impacts: Thoroughly cut from the right to the left. In the event an unexpected inspect the product and identify any problems or damage object or woody stock is encountered, this practice to it.
Symptoms may include tingling, numbness and blanching WARNING of the fingers, usually apparent upon exposure to cold. A leaking fuel cap is a fire hazard and must be replaced Hereditary factors, exposure to cold and dampness, diet, smoking and work practices are all thought to contribute to immediately.
Rotational direction and maximum speed Guaranteed sound power level of the shaft for the cutting attachment. Pull: Quick release tab Sound pressure level at idle Regulatory Compliance Mark (RCM). Product meets applicable regulatory requirements. Run position The following signal words and meanings are intended to Set the choke lever to “Full”...
TROUBLESHOOTING IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT AN AUTHORISED SERVICE CENTRE. PROBLEM POSSIBLE CAUSE SOLUTION Engine will not start No spark The spark plug may be damaged. Remove it and check for dirt and cracks. Replace with a new spark plug. No fuel Push the primer bulb until the bulb is full of fuel.
PRODUCT SPECIFICATIONS REPLACEMENT PART Brushcutter Part Accessory number Part number Model RBC254SSEON Weight 2 mm TRI-ARC PWFBB01 638006011 blade Without fuel, cutting 5.27 kg attachment and harness Without fuel, with blade M8 nut 662450001 5.95 kg and harness Fuel tank volume...
MAINTENANCE SCHEDULE After first Every 3 Every 6 Every year Every 25 Before month or months or months or or after 300 hours each use 20 hours of 50 hours of 100 hours of hours or operation operation operation operation Check if fastener is ■...
Page 32
Imported by: Techtronic Industries Australia Pty. Ltd. 31 Gilby Road, Mount Waverley, VIC 3149 Melbourne, Australia Techtronic Industries N.Z. Limited 2 Landing Drive, Mangere, Auckland, 2022, New Zealand 960405047-01...
Need help?
Do you have a question about the RBC254SSEON and is the answer not in the manual?
Questions and answers