Installation - Lamona LAM3405 Instructions And Installation Manual

Installation

Before installation
The product should only be installed by suitably
The product must be installed in accordance
with all local regulations.
Prior to installation, visually check the product
for any damage/defects. Do not install if any issues
are found.
Damaged products may cause risks to your own
safety.
Tower Installation
20 mm
595mm
595mm
560mm
570mm
min depth
585mm
(min)
560mm
575mm
567mm
20 mm
595mm
594mm
www.howdens.com
The appliance is intended for installation in
Howdens kitchen cabinets.
Surfaces, synthetic laminates and adhesives
used must be heat resistant.
If there is a drawer beneath the oven, a shelf
must be installed between oven and drawer.
The following installation drawings are
representational and may not match exactly
with your appliance.
*
Note: Remove carcass rear panel
to assist with oven ventilation
* A minimum of 150mm² ventilation
gap is required as illustrated
*
(35mm x 500mm cut-out)
570mm
min depth
560mm
575mm
567mm
LAMONA Appliances
560mm
*
585mm
(min)
Built under installation
Page _ 20