Page 2
Select Mode, Total Endurance, TSHARC, WiperLock and ZENA are trademarks of Microchip Technology Incorporated in the U.S.A. and other countries. SQTP is a service mark of Microchip Technology Incorporated in the U.S.A. All other trademarks mentioned herein are property of their respective companies.
DEVICE OVERVIEW Interface Description Figure 1-1 shows a simplified block diagram of the The MRF24J40MB is a 2.4 GHz IEEE Std. 802.15.4™ MRF24J40MB module. The module is based on the compliant, surface mount module with integrated Microchip Technology MRF24J40 IEEE 802.15.4™...
Page 7
1.2", be kept clear of metal objects. A host PCB ground plane around the MRF24J40MB acts as a counterpoise to the PCB antenna. It is recommended to extend the ground plane at least 0.4" around the module.
CIRCUIT DESCRIPTION Schematic A schematic diagram of the module is shown in The MRF24J40MB is a complete 2.4 GHz IEEE Figure 2-1 and the Bill of Materials (BOM) is shown in Std. 802.15.4™ compliant surface mount module with Table 2-1.
Page 12
MRF24J40MB TABLE 2-1: MRF24J40MB BILL OF MATERIALS (CONTINUED) Designator Description Manufacturer Part Number Chip Capacitor 0402 X5R 100N Murata GRM155R61A104KA01D Chip Capacitor 0402 COG 47P Murata GRM1555C1H470JZ01D Chip Capacitor 0603 X5R 2.2U Murata GRM188R60J225ME01D 802.15.4 Radio Microchip MRF24J40-I/ML Switch SPDT...
Page 13
MRF24J40MB Printed Circuit Board The MRF24J40MB module printed circuit board is con- structed with material, four layers 0.032 inches thick. The layers are shown in Figure 2-2 through Figure 2-6. The stack up of the PCB is shown in Figure 2-7.
Canada and European countries. Modular approval with the limits for a Class B digital device, pursuant to allows the end user to place the MRF24J40MB module part 15 of the FCC Rules. These limits are designed to inside a finished product and not require regulatory...
Page 20
Industry Canada. Label: If the MRF24J40MB module is used in a portable Contains IC: 7693A-24J40MB application (antenna is less than 20 cm from persons during operation), the integrator is responsible for From Section 7.1.6, RSS-Gen, Issue 2, June 2007,...
Page 21
Europe 3.3.1 MRF24J40MB SETTINGS To meet ETSI requirements, the following settings must The MRF24J40MB module has been certified for use in be observed by the integrator: European countries. The following testing has been completed: • The MRF24J40MB transmit power setting (RFCON3 0x203) cannot exceed -14.9 dB.
To order or obtain information, e.g., on pricing or delivery, refer to the factory or the listed sales office PART NO. Examples: Device Module Module Tape and Temperature MRF24J40MB-I = Industrial temp. tray Type Reel Range MRF24J40MBT-I = Industrial temp., tape and reel. Device MRF24J40MB;...
Need help?
Do you have a question about the MRF24J40MB and is the answer not in the manual?
Questions and answers