Safely Powering Off The Cisco Asr 914 Router - Cisco ASR 914 Configuration Manual

Hide thumbs Also See for ASR 914:

Safely Powering Off the Cisco ASR 914 Router

This section explains how to shut down the Cisco ASR 914 Router. We recommend that before turning off

all power to the chassis, you issue the reload command. This insures that the operating system cleans up all

the file systems. Once the reload operation is complete, then the Cisco ASR 914 Router can be powered off

safely.

To remove power from the router safely, follow this procedure and see the examples:

Procedure

Step 1

Slip on the ESD-preventive wrist strap that was included in the accessory kit.

Step 2

Enter the reload command.

Step 3

Confirm the reload command.

Example:

Router# reload

Proceed with reload? [confirm]

*Sep 7 09:00:40.084 IST:%SYS-5-RELOAD: Reload requested by console. Reload Reason: Reload

Command.

Sep 7 09:01:02.649 R1/0:%PMAN-5-EXITACTION: Process manager is exiting: process exit with

reload chassis code

Step 4

After confirming the reload command, wait until the system bootstrap message displays before powering off

the system.

Step 5

Remove any power cables from the Cisco ASR 914 Router.

a) For power supplies with a circuit breaker switch, position the switch to the Off (O) position.

b) For power supplies with a Standby switch, place the Standby switch in the Standby position.

After powering off the router, wait a minimum of 30 seconds before powering it on again.

Cisco ASR 914 Aggregation Services Router Hardware Installation Guide

Cisco ASR 914 Router Initial Configuration

Table of Contents