Table of Contents
Advertisement
INTRODUCTION
Card Reader
The CAPXL is designed specifi cally for the LMMC-MINI reader to be mounted on the faceplate.
1. Disconnect power from the CAPXL.
2. Remove and discard the wing nuts and reader cover from the
CAPXL.
3. Install the reader and secure with the screws.
4. Apply silicon around the cable hole.
5. The reader can be wired to any of the 4 Wiegand Inputs on the
door control boards. Insulate any unused wires from the CAPXL
to prevent a short. (Refer to instructions provided with your
reader for more information.)
6. Reconnect power to the CAPXL.
7. Refer to LiftMaster Cloud for programming.
PRE-INSTALL
ON
Reader is wired to WIEGAND INPUT
NOTE: The length of the unshielded
reader wires should be kept to
a minimum to avoid electrical noise.
WIEGAND
INPUT
INSTALL
NETWORK
Reader
Cover
Reader
Use 18-24 AWG
20
ACCESS CONTROL
Wing Nuts
Mounting Plate
Mounting
Holes
Cable
Hole
Mounting Plate
Hide quick links:
Advertisement
Table of Contents
