Table of Contents
Advertisement
INTRODUCTION
1
Connect Internet
The CAPXL can connect to the Internet with a wired connection or with Wi-Fi
Make sure you are in the Admin Mode before you connect to the Internet. If you are not
in Admin Mode, fl ip dipswitch #1 to the ON position on the Power/Internet board, press
the Network tab on the CAPXL display, and press the "Change Network Settings" button.
Follow the instructions according to your application.
OPTION 1
The Local Area Network (LAN) port is a 10/100/1000 Ethernet interface with an RJ45 jack for connecting the CAPXL to a
hub, switch, or router in order for it to gain connectivity to the Internet. Use a straight, (i.e., non-crossover) Cat5, Cat5e,
or Cat6 cable to connect to a local hub, switch or router. This type of cable is referred to as an Ethernet cable in this
manual.
1. Open the Ferrite Core.
2. Loop the Input Ethernet cable around itself one time, creating
a loop large enough to fi t over the length of the Ferrite Core.
Locate the cable loop near the intended electrical knock-out.
3. Place looped section of Input Ethernet cable
over one side of the open Ferrite Core.
4. Close the Ferrite Core securely and plug the
Input Ethernet cable into the Power/Internet
board.
5. Connect an Ethernet cable from the hub, switch,
or router to the LAN port on the Power/Internet
Board. When connected properly, the green and
amber LED on the Ethernet port of the control
board will light/fl icker (the control board is
located on the back of the CAPXL display). If the
green LED is not lit, check the connections on
the CAPXL and the Ethernet hub.
6. On the display, select Wired Network if dynamic
confi guration (DHCP) is desired or select
Manual Setup for a static IP address.
OPTION 2
1. On the display select Wi-Fi Network.
2. Select the network the CAPXL will use.
3. Enter the password for the network.
4. Select Login.
2
Validate Setup
On the display, select each tab in Admin Mode to validate setup (network,
inputs, outputs, etc.). Once you have validated the setup, exit Admin Mode.
PRE-INSTALL
Wired Connection
Connect through Wi-Fi
®
(Wireless)
INSTALL
NETWORK
®
LAN on
Power/Internet Board
Ferrite Core
(325 feet [99.1 m] maximum)
Router/Switch
16
ACCESS CONTROL
(wireless).
ON
Input Ethernet
Cable
ON
Ethernet Cable
Modem
Dipswitch #1 on the
Power/Internet board
ON
Ferrite Core
Hide quick links:
Advertisement
Table of Contents
