Gate Access (Wireless) - Chamberlain CAPXL Installation Manual

INTRODUCTION

Gate Access (Wireless)

The CAPXL can communicate wirelessly to LiftMaster
send email notifi cations if an error occurs in the operator (email notifi cations are confi gured in LiftMaster Cloud). Up to 8 gate operators
can be paired with the CAPXL - one for each primary and auxiliary relay. If using dual gates, program the CAPXL to the primary operator.
1
Enter Admin Mode
Flip dipswitch #1 to the ON position to
enter Admin Mode.
ON
NOTE: For new installations press
the login button without entering
information in the Admin Username
and Admin Password fi elds.
4
Press LEARN button on gate
operator again
Press and release the LEARN button
again on the primary operator. The
yellow NETWORK LED will light.
PRE-INSTALL
®
UL325 2016 gate operators to send open commands, monitor gate position, and
2
Select Outputs and Relay
Select the Outputs tab. Then select the
desired relay on the left-hand side (1
through 4).
ON
5
Select LEARN on display
Select the LEARN button on the
display and the Learn button will go
from blue to red. The gate operator
and the CAPXL will beep once and the
NETWORK LED on the gate operator
will turn off indicating programming is
successful.
NOTE: 4 beeps/blinks indicate you
are not programming to the primary
operator. Reattempt programming
from the other operator.
INSTALL NETWORK
18
ACCESS CONTROL
3
Press LEARN button on gate
operator
Press and release the LEARN button
on the primary operator. The green
XMITTER LED will light. NOTE: The
operator will time out of programming
mode after 180 seconds.
6
Validate
Validate functionality by selecting Test
Relay on the CAPXL display.