Samsung WF16J6 User Manual page 47

Code
4C2
5C
HC
HC2
UB
8C, 8C1, 8C2
OC
3C
AC6
DDC
WF16J6500EV_DC68-03665C_EN.indd 47
Laundry needs protection because the water being supplied is
too hot.
• Make sure the cold and hot water taps are properly
connected.
• Power off and power the machine on after 2-3 minutes, and
then try again.
Check the drain system.
• Make sure the drain filter is not clogged.
• If the drain filter is clogged, clean the filter and restart the
machine.
Check the washing heater.
• Power off the machine and contact a local Samsung service
centre.
Check the drying heater.
• Power off and power the machine on after 2-3 minutes, and
then try again.
Check the spinning process.
• The load may not be balanced inside the drum. Check the
drum and make sure the load is balanced.
• Press START/PAUSE to resume operation, or power off and
power the machine on after 2-3 minutes, and then try again.
Check the MEMS sensor.
• Power off and power the machine on after 2-3 minutes, and
then try again.
Water may overflow.
• Close the water valve and call for service.
Check the motor.
• Power off and power the machine on after 2-3 minutes, and
then try again.
Check the PBA communication status.
• Power off and power the machine on after 2-3 minutes, and
then try again.
The Add Door is open.
• Close the Add Door and press START/PAUSE to resume
operation.
Action
English 47
2017/10/20 14:27:57