Installation 3 - Aaeon SBC-659 Manual

Half-s i z e C P U C a r d

4.3 Installation 3:

Applicable for Windows NT 4.0
1. Insert the SBC-659 REV. B CD ROM into the CD-ROM
Drive.
2. Start system with Windows NT 4.0 installed.
IMPORTANT: When the "Please select the operating system
to start..." message is displayed, select "Windows NT
Workstation Version 4.00 [VGA mode]".
3. From Start, select the Settings group and then click on the
Control Panel icon.
4. In the Control Panel, select the desired device and click on the
icon.
5. Follow the step-b y-step instruction and click on OK button.
6. Click on the Have Disk... button.
7. Key in CD-ROM path and specify component drivers, then click
on the OK button.
8. From the list of displayed devices, select your desired device.
9. If a message appears stating the driver is already installed on the
system, and asks if you want to use the current or new drivers, be
sure to select the New button.
10. If prompted for the driver diskette a second time, click on the
Continue button.
(Notice: In some cases the system will ask you to insert
Windows NT CD ROM. Follow its instructions to complete
the setup procedures.)
11. When the message "The drivers were successfully installed"
is displayed, click on the OK button.
12. Reboot the system.
Chapter4 Drivers Installation
S B C - 6 5 9 R e v . B
4 - 5