Replacing Damaged Blades And Guards - Brookstone Flight Force Manual

RE-CALIBRATING
If the drone and controller become unsynchronized, such as after a serious crash, you
can re-calibrate them.
To re-calibrate the drone and controller:
1. Place the drone on a flat surface.
2. Slide the controller's Power Switch to the ON
position.
3. Press the controller's left and right control
sticks down and out, as illustrated.
4. When calibrated, a tone will sound and the LED lights stop flashing. The
controller and drone are now calibrated.
14
REPLACING DAMAGED BLADES AND
GUARDS
The drone has four rotor blades and four blade guards. If a blade or guard becomes
damaged, you can replace it with the included replacement blades and guards.
Blades are labeled A1, A2, B1, or B2. You must replace A blades with A blades,
and B blades with B blades. To replace a blade, pull the blade off of its pin and
press the new blade onto the pin. Blades are intentionally difficult to remove; use of
tools such as a wrench and pliers may be helpful.
To replace a guard, pull the guard out of its slot and press the new one into the slot.
If you need additional replacement rotor blades or guards, contact Brookstone
Customer Service at 800-292-9819.
15