Low Voltage Protection; Trimming The Drone; Headless Mode Function; Ending Flight - Brookstone Flight Force Manual

LOW VOLTAGE PROTECTION

When the battery is low, the LEDs on the drone begin to flash quickly. Land the
drone as soon as possible and recharge the battery, as described on Page 8. If the
battery becomes too depleted, the drone will enter low-voltage protection and the
power system will automatically shut down.
NOTE: The drone will lose power as the battery becomes depleted. Push the left
joystick up to maintain your preferred height.

TRIMMING THE DRONE

To ensure that your drone can fly straight and level, you must trim the aircraft so it
remains stable both in takeoff and in flight.
• If the drone drifts slightly to the right, press the Left
Trim Button.
• If the drone drifts slightly to the left, press the Right
Trim Button.
• If the drone drifts slightly backward, press the Forward
Trim Button.
• If the drone drifts slightly forward, press the Backward
Trim Button.
NOTE: It is best to make final trim adjustments when the craft is airborne.
12
Left/Right Trim Button
Forward/Backward Trim Button

HEADLESS MODE FUNCTION

Headless Mode allows you to set forward, backward, left and right directions relative
to the drone's position from you. Left turns to your left, right turns to your right,
regardless of the position of the front and back of the drone.
To activate Headless Mode, ensure that the nose of the
drone is facing away from you, then press the Headless
Mode button and hold for 2 seconds. The LEDs on the
drone will flash slowly, indicating that Headless Mode is
activated.
To exit Headless Mode, press the Headless Mode button again.

ENDING FLIGHT

To end your flight, do one of the following:
• Press the right and left joysticks to the right corner at
the same time,
or,
• Press the One Key Landing button for two seconds.
The drone will land and the rotor blades will stop spinning. Unplug the Charging/
Power Connector from the drone and turn off the controller.
Headless Mode Button
One Key Landing Button
13