Dataport V2 Application Information - QSC ISA 300T User Manual

APPLICATIONS:
Below are listed the available QSC DataPort-compatible products that will interface with your ISA amplifier. This list will continuously
change as new products become available and old products are discontinued. Always use a QSC DataPort cable for remote equipment
interconnect. Computer data cables, although similar in appearance, will not function properly and may damage your equipment.
Contact your QSC dealer for details and for QSC accessories. This listing is current at time of writing, for up-to-date accessory
information, contact your QSC representative.
The DSP-3 Digital Signal Processing Module provides compressor-limiter, multiple parametric filters, high- and low-pass filters,
shelf filters, multiple delays, polarity reversal, muting and attenuation. These features and more come packed into a small module that
interfaces with the DataPort V2 connector on the rear of your ISA amplifier. Not all features of the DSP-3 are available via the "Version
2" DataPort; consult your QSC sales professional for full details. The accessory remote power supply must be used to supply DC power
to the DSP-3; accessory module power is NOT provided by the ISA amplifiers.
The XC-3 Crossover provides a built-in active two-way crossover. It features fourth-order Linkwitz-Riley filters with SIP selectable
crossover frequencies, DIP-switch control of high-frequency equalization for CD horn equalization, SIP selectable subsonic filter, and
SIP selectable all-pass low-frequency delay.
The SF-3 Subwoofer Filter is used primarily as an adjustable bandpass filter for subwoofers. The filter may be configured for a flat
roll-off or a boosted response to equalize certain subwoofer models with step-down tuning. The use of a subsonic filter at the vented
box tuning frequency protects speakers from damage and prevents the waste of amplifier power on excessive and inaudible low-
frequency noise.
The LF-3 Low Frequency Filter is a new module for tri-amp applications. The LF-3 provides low-frequency bandpass filters for each
amp channel and is used in conjunction with XC-3's to power a tri-amp system. The XC-3 provides mid and high-pass functions for each
speaker system.
The DCM Crossover & Monitors will work with the ISA amplifiers. The "AMP TYPE" selection in software MUST be set to UN-
KNOWN. This will disable the load fault detection and AC power control as these features are not supported by the ISA series. Consult
your QSC applications engineer regarding integration of ISA amplifiers with DCM products.
The CM16a Amplifier Network Monitor will not work with the ISA series of amplifiers.
Always use a QSC DataPort cable for remote equipment interconnect.
Computer data cables, although similar in appearance, will not
function properly and may damage your equipment.
32
DataPort V2 (all models)