Ryobi RPP720 Operator's Manual

Ryobi RPP720 Operator's Manual

Electric pole pruner
Hide thumbs Also See for RPP720:

Advertisement

RPP720
ELECTRIC POLE PRUNER
OPERATOR'S MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RPP720 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Ryobi RPP720

  • Page 1 RPP720 ELECTRIC POLE PRUNER OPERATOR’S MANUAL...
  • Page 2 Important! It is essential that you read the instructions in this manual before mounting and operating this machine. Subject to technical modifications.
  • Page 3: General Safety Rules

    ENGLISH GENERaL SaFETY RULES aDDITIONaL SaFETY RULES Never allow children or people unfamiliar with these WaRNING instructions to use the appliance. When using electric gardening appliances, basic Only use in daylight or in good artificial light. safety precautions should always be followed to reduce the risk of fire, electric shock and personal The appliance should be inspected and maintained injury, including the following:...
  • Page 4: Specifications

    ENGLISH SYMBOLS SYMBOL EXPLaNaTION Voltage Current Frequency(cycles per second) Power Time Rotational speed, at no load double-insulated construction .../min Revolutions, strokes, surface speed, orbits etc., per minute Warning Read the instruction manual Don’t expose to moisture Disconnect the mains plug if the cord is damaged or entangled Keep bystanders away, be aware of the falling objects Electrical hazard , at least 5m away from the overhead lines Wear non-slip, heavy-duty protective gloves when handing the pole saw and the blade.
  • Page 5: Packing List

    ENGLISH Fig.2 4. Chain Tensioning Screw . Pole Figure 15: . Button 3. Collar . Bar Nut 4. Threaded Base Figure 16: 5. Cord 6. Intermediate Pole . Remove Cap 7. Powerhead Pole . Bar Lube 8. Strap Hanger 3. Reservoir 9.
  • Page 6: Connecting To Power Supply

    See Figure 3 Before using the pole saw, a one-time assembly is Use Ryobi Bar and Chain Lubricant. It is designed for required. When removed from the box, the three poles chains and chain oilers, and is formulated to perform over are connected by an electrical cord as shown in Figure .
  • Page 7 ENGLISH NOTE: Failure to remove all excess cord slack from Follow the steps below to prevent damage to tree or shrub bark. Do not use a back-and-forth sawing motion. extension cord retainer could result in plug loosening from receptacle. Make a shallow first cut (/4 of limb diameter) on the underside of the limb close to the main limb or trunk.
  • Page 8: General Maintenance

    ENGLISH to reduce the weight. Following proper cutting Stop the motor and disconnect from power supply procedures will prevent stripping the bark from the before setting the chain tension. Make sure the main member. guide bar nut is loose to finger tight, turn the chain tensioning screw clockwise to tension the chain.
  • Page 9: Chain Oiler

    ENGLISH NOTE: If chain is too tight, it will not rotate. Loosen Use a 4mm(5/3), diameter round file and holder. the bar nut slightly and turn adjusting screw /4 Keep the file level with the top plate of the tooth. Do not turn counterclockwise.
  • Page 10: Troubleshooting

    ENGLISH TROUBLESHOOTING PROBLEM POSSIBLE CaUSE REMEDY Bar and chain running hot Check chain tension for overtightened Tension chain. Refer to Chain Tension earlier in this and smoking. condition manual. Bar lube reservoir empty. Check bar lube reservoir and re-fill. Retention chain. Refer to Chain Tension earlier in this Motor runs, but chain is Chain tension too tight.
  • Page 11: Limited Warranty

    DAMAGES. OUR MAXIMUM LIABILITY SHALL NOT EXCEED THE ACTUAL PURCHASE PRICE PAID BY YOU FOR THE PRODUCT. This warranty is valid only in the European Union, Australia and New Zealand. Outside these areas, please contact your authorized Ryobi dealer to determine if another warranty applies.
  • Page 12 RYOBI TECHNOLOGIES (UK) LIMITED. Itterpark 4 Medina House, D-4074 Hilden Fieldhouse Lane, Marlow, DEUTSCHLAND Buckinghamshire, Tel: + 49 (0) 03 958-0 Fax: + 49 (0) 03 958-9 SL7 TB, UNITED KINGDOM Tel: + 44 (0) 68 894400 RYOBI TECHNOLOGIES GMBH Fax: + 44 (0) 68 89440 Vertriebsbüro Österreich...

Table of Contents

Save PDF