QSC Network Audio Systems Owner's Manual page 5

QSControl Network Audio Systems
Port A Ch 1
Sensitivity
Audio
Port A Ch 2
Inputs
Sensitivity
Power Standby / Output
Status Operate Open
Detect Control Detect
Amp Bridge Output
Model Mode Open
Detect Detect Detect
Amp Functions
Input
Input
Sensitivity
3V / 1V
Page Internal DAC
(for Test Tones
and Playback)
Input
Monitor
Chain
RS-232
Serial I/O (DB-9)
Block Diagram of the CM16a
Input
Input
Source
Normal
3V / 1V
Mon (Pre)
/ Page
Input
Input Parallel
Source
Normal
3V / 1V Stereo Mode
/ Page Mon (Pre)
Output Protect Load
Short Status Monitor
Detect Detect Detect
Output Protect Load
Short Status Monitor
Detect Detect Detect
DataPorts B through H (same as DataPort A)
Audio Monitor Chain
From
Mon
Tap Points
Minimum Recommended Specifications for the System Controller
Processor 866 MHz Intel Pentium™ III processor
RAM 128 MB, 133 MHz bus
Hard Disk 4 GB or greater Ultra DMA
Floppy 3.5" 1.44 MB drive
CD-Rom 40x or greater IDE
Network 10/100
Network Configuration TCP/IP host
Modem 56k V.90 internal PCI (optional)
Video 2D/3D Graphics, 133/100 MHz, 4 MB Display cache or better
Sound Sound Blaster® compatible (optional)
Keyboard 104 key, PS/2 compatible
Mouse PS/2 compatible
Operating System Windows NT-4 (SP-6) or Windows 2000 (SP-2)
All specifications are subject to change.
Meter
Level Control
-95.5 to 0 dB Mute
0.5 dB steps
Meter
Level Control
-95.5 to 0 dB Mute
0.5 dB steps
Real Amp Over-
Clip
Power Gain temp
Detect
Detect Detect Detect
Real Amp Over-
Clip
Power Gain temp
Detect
Detect Detect Detect
DataPort A
(Summing Bus)
Mon 1
Up to four signals may be
Mon 2
sent to the Monitor Bus at
Mon 3
one time. Each tap has
Mon 4
its own gain adjust.
-T
BASE
Meter
Ch 1
Polarity
Mon (Post)
Meter
Ch 2
Polarity
Mon (Post)
Heat- Head- Output Output
sink room Current Voltage
Temp Meter Meter Meter
Heat- Head- Output Output
sink room Current Voltage
Temp Meter Meter Meter
NO NC
RLY
C
RLY
Trig in
Output
Ethernet
Internal
Micro-Controller
Ch 1
Functions
Mon (Amp)
Mon (Amp)
Ch 2
Functions
RLY
Out
Contact
Closure
I/O
Monitor
Chain